Nortel Networks BCM200, 400 4.0 manual To attach the rack-mount brackets

Chapter 6 Installing the BCM main unit 93

To attach the rack-mount brackets

1Place the BCM main unit on a flat, clean surface.

2Align the screw holes between the BCM main unit and the right rack-mount bracket.

3Fasten the bracket to the BCM main unit using four screws.

Caution: Use only the screws supplied with the rack-mount bracket. Do not replace the screws. Other screws can damage the unit.

4Align the screw holes between the BCM main unit and the left rack-mount bracket.

5Fasten the bracket to the main unit using four screws. Refer to Figure 51, Figure 52, or Figure 53.

Note: Rack-mount bracket

The expansion unit rack-mount bracket has an additional set of holes that allows you to install the brackets so that the expansion unit sits flush with the BCM main unit in an equipment rack.

Figure 51 Attach the rack-mount bracket to the BCM200 main unit

Install rack-mount

bracket screws

BCM200/400 4.0 Installation and Maintenance Guide