Nortel Networks 400 4.0, BCM200 manual Installing the main unit on the wall

96Chapter 6 Installing the BCM main unit

Figure 56 Fasten the expansion unit to the equipment rack

Installing the main unit on the wall

This procedure describes how to mount the BCM200 or BCM400 main unit to a wall.

To mount the main unit on the wall, you need:

•a wall-mount bracket kit NTAB3422

•four #10 x 2.5 cm (#10 x 1 in.) round-head wood screws

•a plywood backboard 2 cm (3/4 in.) thick

To mount the expansion unit on the wall, you need:

•a wall-mount bracket (supplied with the unit)

•two #10 x 2.5 cm (#10 x 1 in.) round-head wood screws

•a plywood backboard 2 cm (3/4 in.) thick

Caution: Refer to “Environmental requirements” on page 87 for acceptable environmental conditions before selecting a location for the BCM main unit.

Note: Nortel does not recommended use of the rack-mount brackets for wall-mount applications.

To install the main unit on the wall

1Mark the location of the plywood backboard on the wall using a pencil. Use a ruler and bubble-level to check that the plywood backboard is level with respect to the wall.

2Mount the plywood backboard securely to the wall.

N0060612