Nortel Networks 400 4.0, BCM200 manual Moving telephones

166Chapter 10 Installing telephones and peripherals

T7406 cordless telephones use the DNs for the ports on the station module that is connected to the base station. They are digital sets and use M7310/T7316 as an operational model.

Moving telephones

You can move a BCM digital telephone to a new location within the system without losing its programmed settings, if the telephone has been enabled with Set relocation (automatic telephone relocation). When you enable Set relocation, the internal numbers, auto-dial settings, and personal speed dial codes remain with the telephone when you disconnect the telephone.

If you connect a different telephone to the jack before you reconnect the moved telephone, the new telephone takes the programmed settings. The BCM system can no longer identify the old telephone.

After you plug a moved set into a new jack, the BCM system can take 45 seconds to identify the telephone. Programming relocation takes 3 minutes to complete. Wait for this to occur before you change any settings for the telephone in the system.

Warning: If you disconnect a relocated telephone before the relocation programming is complete, the telephone can lose the programmed settings.

I

Note: Automatic telephone relocation is disabled by default.

For IP telephones to retain DN-specific features, the Keep DN Alive setting for the telephone programming must be selected.

N0060612