Nortel Networks BCM200, 400 4.0 manual Installing a hard disk cage in a BCM400 main unit

Chapter 22 Replacing the hard disk 263

Figure 125 Insert the hard disk cage into the BCM200 main unit

Slide the hard disk cage toward the front of the main unit.

7Replace the cover (if applicable) and access panel.

8Restore the BCM system to operation. Refer to “Restarting the system after maintenance” on page 232.

9If you installed a new programmed hard disk in a standard configuration (for RAID configuration, skip to the next step):

a Initialize the hard disk. Refer to “Initializing the hard disk in a single-disk configuration” on page 273.

b After the disk is initialized, restore your data from your backups. If you did not back up your keycodes, reenter them (see “Software keycode” on page 181).

10If you installed a new blank hard disk (mirror or primary) in a RAID, wait for the disk mirror process to complete. For further information on how to monitor disk mirroring progress, refer to “RAID disk mirroring” on page 221.

Installing a hard disk cage in a BCM400 main unit

Use this procedure to install the standard or RAID configuration hard disk cage into the BCM400 advanced function tray.

Warning: Protect the hardware components against damage from electrostatic discharge. Always wear a grounded wriststrap before you handle components. Always place the components in a static-free container.

To install a hard disk cage

1Disconnect the BCM system from the AC power source.

2Attach one end of the grounding strap to your wrist and the other end to a grounded metal surface.

BCM200/400 4.0 Installation and Maintenance Guide