Nortel Networks 400 4.0, BCM200 manual Remove the power supply module from the power supply cage

298Chapter 23 Replacing or upgrading a power supply

•If you are installing the redundant power supply for the first time, remove both power supply modules from the redundant power supply cage. Remove the power supply modules before you install the power supply in the platform base chassis (see Figure 159).

Figure 159 Remove the power supply module from the power supply cage

Rear view:

Power supply modules slide out of the power supply cage.

Compress the locking 3 tab toward the handle

	Lift the power supply	1 Unfasten the power supply
2		module locking nut
	module handle

5Place the power supply module on a flat, clean, static-free surface.

6Repeat this step for any remaining power supply modules.

N0060612