Nortel Networks 400 4.0, BCM200 manual To select the telephony startup template and start DN

190 Chapter 15 Using Telset Administration to set the basic parameters

To select the telephony startup template and start DN

You set the template and start DN using Feature **STARTUP from a two-line display telephone.

Note: You can only set these parameters for only 15 minutes after system bootup.

Refer to the BCM 4.0 Telset Administration Guide for information on using Telset Administration to set this parameter.

Other telephony startup parameters are configured using Feature **CONFIG. Refer to the BCM 4.0 Telset Administration Guide for more information.

To initialize voice mail

You initialize your voice mail system using Feature 983 from a two-line display telephone.

Refer to the CallPilot Telephone Administation Guide for information on using Telset Administration to initialize your voice mail system.

To create Telset user accounts

Note: You can only create Telset accounts using Telset Administration. To create Element Manager accounts, you must use Element Manager.

1Select Feature 9*8 from a two-line display telephone.

2Enter the following user ID and password: User ID: SETNNA

Password: CONFIG

The numerical values of the user ID and password are 738662 and 266344, respectively.

3Press NEXT to scroll through the menu and select User Accounts.

4Press OK. The Accounts screen appears.

5Press NEXT to scroll through the list of available accounts to create.

6Press CHNGE to change the status of the current account.

7Press CRT to create the account.

If you see the DEL command instead of the CRT command, then the account is already created.

8Press BACK. The Accounts screen appears.

9Press NEXT. The password screen appears.

10Press CHNGE to change the password.

11Press NEXT to scroll through the list of available accounts.

N0060612