Jonsered FC 2145S manual Fueling, Mixing

Page 19

FUEL HANDLING

Mixing

Always mix the gasoline and oil in a clean container intended for fuel.

Always start by filling half the amount of the gasoline to be used. Then add the entire amount of oil. Mix (shake) the fuel mixture. Add the remaining amount of gasoline.

Mix (shake) the fuel mixture thoroughly before filling the machine’s fuel tank.

Do not mix more than one month’s supply of fuel at a time.

If the machine is not used for some time the fuel tank should be emptied and cleaned.

WARNING! The catalytic converter muffler

!gets very hot during and after use. This also applies during idling. Be aware of the fire hazard, especially when working near flammable substances and/or vapours.

Fueling

WARNING! Taking the following precautions,

!will lessen the risk of fire:

Do not smoke or place hot objects near fuel. Always shut off the engine before refuelling.

Always stop the engine and let it cool for a few minutes before refuelling.

When refuelling, open the fuel cap slowly so that any excess pressure is released gently.

Tighten the fuel cap carefully after refuelling.

Always move the machine away from the refuelling area before starting.

Clean the area around the fuel cap. Contamination in the tank can cause operating problems.

Ensure that the fuel is well mixed by shaking the container before filling the tank.

English – 19

Image 19
Contents Operator’s manual EPA Symbols KEY to SymbolsContents Dear customer IntroductionWhat is what on the clearing saw? BC What is WHAT?What is what on the clearing saw? FC 2145, FC 2145 S Personal protective equipment General Safety PrecautionsStop switch Machine′s safety equipmentThrottle lock Muffler Cutting attachment guardVibration damping system Quick releaseLocking screw Locking nutCutting equipment Cutting equipmentSharpening grass cutters and grass blades Trimmer head Sharpening the saw bladeFC 2145, FC 2145 S AssemblyAssembling the handlebar and throttle Transport position, handlebarFitting blades and trimmer heads Fitting the trimmer guard and trimmer head Trimmy SII Fitting the blade guard and saw bladeFitting other guards and cutting attachments Adjusting the harness and clearing sawStandard harness Grass clearing Adjusting the harnessVector harness Correct balanceFuel Handling Fuel safetyFuel Mixing FuelingCold engine Starting and StoppingCheck before starting Starting and stoppingStopping StartingABC of clearing Basic safety rulesWorking Techniques General working instructionsWorking methods Forestry clearing using a saw bladeBrush cutting with a saw blade Grass clearing using a grass bladeTrimming Grass trimming with a trimmer headCarburetor MaintenanceHigh speed jet H Fine adjustment of the idle speed TCorrectly adjusted carburetor Adjusting the start throttle speed BCCooling system MufflerAir filter Spark plug Cleaning the air filterBevel gear Drive shaftWinter use Temperature 0C 32F or colderMaintenance Daily Weekly Monthly Maintenance scheduleTechnical data Technical DataApproved accessories Type Cutting attachment guard, Art. no Your Warranty Rights and Obligations Federal Emission Control Warranty StatementPoly Trim Clic 35-50 NM 095-.130Page Mm 9,0 m Mm 7,5 m Mm 6,0 m 15 cm 10 m 10 cm 15 cm Clic 1088930-95 ´z*x¶5¢¨ ´z*x¶5¢¨