Jonsered FC 2145S manual Starting, Stopping

Page 21

STARTING AND STOPPING

If the machine is ﬁtted with a decompression valve (A): Press the valve to reduce the pressure in the cylinder and make starting easier. You should always use the decompression valve when starting the machine. Once the machine has started the valve will automatically return to its original setting.

Starting

Hold the body of the machine on the ground using your left hand (CAUTION! Not with your foot!). Grip the starter handle, slowly pull out the cord with your right hand until you feel some resistance (the starter pawls grip), now quickly and powerfully pull the cord.

Repeat pulling the cord until the engine starts. When the engine starts. return choke control to run position and apply full throttle; the throttle will automatically disengage from the start setting. Never wrap the starter cord around your hand

CAUTION! Do not pull the starter cord all the way out and do not let go of the starter handle when the cord is fully extended. This can damage the machine.

Stopping

Stop the engine by switching off the ignition.

BC 2145		FC 2145

WARNING! When the engine is started with

!the choke in either the choke or start throttle positions the cutting attachment will start to rotate immediately.

English – 21

Image 21

Contents Operator’s manual EPA Symbols KEY to SymbolsContents Dear customer IntroductionWhat is what on the clearing saw? BC What is WHAT?What is what on the clearing saw? FC 2145, FC 2145 S Personal protective equipment General Safety PrecautionsMachine′s safety equipment Stop switchThrottle lock Vibration damping system Cutting attachment guardQuick release MufﬂerLocking screw Locking nutCutting equipment Cutting equipmentSharpening grass cutters and grass blades Trimmer head Sharpening the saw bladeAssembling the handlebar and throttle AssemblyTransport position, handlebar FC 2145, FC 2145 SFitting blades and trimmer heads Fitting the trimmer guard and trimmer head Trimmy SII Fitting the blade guard and saw bladeAdjusting the harness and clearing saw Fitting other guards and cutting attachmentsStandard harness Vector harness Adjusting the harnessCorrect balance Grass clearingFuel safety Fuel HandlingFuel Mixing FuelingCheck before starting Starting and StoppingStarting and stopping Cold engineStopping StartingWorking Techniques Basic safety rulesGeneral working instructions ABC of clearingWorking methods Forestry clearing using a saw bladeBrush cutting with a saw blade Grass clearing using a grass bladeTrimming Grass trimming with a trimmer headCarburetor MaintenanceCorrectly adjusted carburetor Fine adjustment of the idle speed TAdjusting the start throttle speed BC High speed jet HMufﬂer Cooling systemAir ﬁlter Bevel gear Cleaning the air ﬁlterDrive shaft Spark plugWinter use Temperature 0C 32F or colderMaintenance Daily Weekly Monthly Maintenance scheduleTechnical data Technical DataApproved accessories Type Cutting attachment guard, Art. no Your Warranty Rights and Obligations Federal Emission Control Warranty StatementPoly Trim Clic 35-50 NM 095-.130Page Mm 9,0 m Mm 7,5 m Mm 6,0 m 15 cm 10 m 10 cm 15 cm Clic 1088930-95 ´z*x¶5¢¨ ´z*x¶5¢¨