MAINTENANCE
Air filter
The air filter must be regularly cleaned from dust and dirt in order to avoid:
• Carburetor malfunctions
• Starting problems
•Engine power reduction
•Unnecessary wear on the engine parts
• Abnormal fuel consumption
Clean the air filter daily or more often if the air is exceptionally dusty in the working area.
• Disassemble the air filter by removing the cylinder cover and unscrew the filter.
When reassembling, make sure that the filter is tight against the filter holder. Clean the filter by brushing or shaking it.
• A more thorough cleaning of the filter is obtained by washing it in water and soap.
An air filter, which is used for some time, cannot be cleaned completely. Therefore it must be replaced by a new one, with regular intervals.
IMPORTANT! A damaged air filter must always be replaced.
A Jonsered chain saw can be equipped with different types of
Muffler
The muffler is designed in order to reduce the noise level and to direct the exhaust
gases away from the operator. The exhaust gases are hot
and can contain sparks, which may cause fire if directed against dry and combustible material. Some mufflers are equipped with a special screen.
If your saw has this type of muffler, you should clean the screen at least once a week. This is done with a wire brush.
CAUTION! The screen must be replaced, if damaged. The saw will be overheated, if the screen is clogged. This results in damage on the cylinder and the piston. Never use a saw with a clogged or defective muffler.
A muffler fitted with a catalytic converter reduces the concent- ration of hydrocarbons (HC), oxides of nitrogen (NO) and aldehydes emitted with exhaust gases. However, it does not cut down carbon monoxide (CO), which you cannot smell! Do not run a chain saw in an unventilated area.
WARNING!
The catalytic converter muffler gets very hot during and after use. This also applies during idling. Be aware of the fire hazard, especially when handling the saw near flammable substances or vapours.
Needle bearing maintenance
airfilter according to working and weather conditions, season etc.
Spark plug
The spark plug condition is influenced by:
•An incorrect carburetor setting.
•Wrong fuel mixture (too much oil in the gasoline).
•A dirty air filter.
These factors cause deposits on the spark plug electrodes, which may result in malfunction and starting difficulties.
If the engine is low on | 0,5 mm | |
power, difficult to start or | ||
| ||
runs poorly at idling speed, |
| |
always check the spark plug |
| |
first. If the spark plug is dirty, |
| |
clean it and check the |
| |
electrode gap. Readjust if |
| |
necessary. The correct gap is |
| |
0,5 mm (0,020"). The spark |
| |
plug should be replaced after |
| |
about a month in operation or |
| |
earlier if the electrodes are |
| |
badly eroded. |
|
IMPORTANT! Always use the recommended spark plug type. An incorrect spark plug can severely damage the piston/cylinder.
The clutch drum is equipped with one of the following chain sprockets:
•Spur sprocket (A) (the chain sprocket is welded on the drum)
•Rim sprocket (B) (exchangeable)
Both versions have
NOTE! Use only high quality bearing grease.
A |
B |
English – 31