J-Allure
Fixed Panels Installation (cont.)
Install the two wall extrusions on the ends of the fixed panel assembly. Make sure they are flush against each fixed panel.
Where the fixed panel assembly will rest on the bath rim, apply sealant. Position the fixed panel assembly on the bath by inserting the pin into its seat on the lower guide. The curve of the fixed panel should match the curve of the bath. Lift left side wall through the open doors. Insert the 3 bolts (welded on the side wall frame) into the slotted holes in the center panel frame. Place the opposite side of the side wall against the fixed panel frame. Make sure the wall extrusion is against the wall. Check perpendicularity with a level. Mark this wall extrusion position. Remove left side wall and repeat the above steps for the right side wall. Remove this side wall and fixed panels assembly.
Using the 3 holes in each extrusion as a guide, drill three 15/64" holes into adjacent wall for each side. Attach the wall extrusions to the walls with the anchors and 3.5x32mm screws. Drill three 7/64" holes into the fixed panel frame using the wall extrusion holes as guides. Secure the panel frame to the wall extrusion with 3.5x9.5mm
WALL
EXTRUSION
FIXED PANEL
ASSEMBLY
WALL | FIXED PANEL |
EXTRUSION | ASSEMBLY |
PIN
FRAME OF
CENTER PANEL
SIDE | SEALANT | |
WALL | ||
|
FIXED
PANEL
FRAME
MARK
15