Ht-Eq, CH Input | Marantz SR4300 instruction

ENGLISH

HT-EQ

AV SURROUND RECEIVER SR4300

SURROUND

Press the HT-EQbutton on the front panel to turn on the HT-EQ mode. The tonal balance of a film soundtrack will be excessively bright and harsh when played back over audio equipment in the home. This is because film soundtracks were designed to be played back in large movie theater environments.

Activating the HT-EQ feature when watching a film made for movie theaters corrects this and restores the correct tonal balance.

The HT-EQ feature can be activated only while in Dolby Pro Logic Mode, or while decoding Dolby Digital or DTS encoded material.

6.1 CH INPUT.

The SR4300 is equipped for future expansion through the use of Multi channel SACD multi channel player or DVD-Audio player.

This is selected, the input signals connected to the Front left, Front right, Center, Surround left, Ssurround right and Surround back channels of the 6.1 CH. In jacks are output directly to the front (left and right), center, surround (left and right) and surround back speaker systems as well as the pre-out jacks without passing through the surround circuitry.

In addition, the signal input to the SW (subwoofer) jack is output to the PRE OUT SW (subwoofer) jack.

When 6.1 CH. INPUT is selected, the last video input used remains routed to the Monitor Outputs.

This permits simultaneous viewing with video sources.

		AUTO		DTS
AV SURROUND RECEIVER SR4300
SURROUND		1	2	3
	TREBLE	CS	EX/ES	DSP
		4	5	6
		M-CH	2CH	6.1CH
		ST		-IN
2.		7	8	9
2.	BASS	F.DIRECT	A/D
			0
				OFF
	SETUP/T.TONE			MENU

1. Select a desired Video source to decide the routed video signal to the Monitor Outputs .

2. Press the 6.1 CH-INbutton on the front panel or on the remote to switch the 6.1 channel input.

3. If necessary to adjust the output level of each channel, use “6.1 Ch. INPUT LEVEL” in SETUP menu system as desired.

Adjust the speaker output levels so that you can hear the same sound level from each speaker at the listening position. For the front left, front right, center, surround left, surround right and surround back speakers, the output levels can be adjusted between –10 to +10 dB.

The subwoofer can be adjusted between –15 and +10 dB. These adjusting result will be stored to 6.1 Ch. INPUT condition. (see to page 24)

4. Adjust the main volume with the MAIN VOLUME knob or the VOL buttons on the remote.

To cancel the 6.1 Ch. INPUT setting, press the 6.1 CH-INbutton on the front panel or on the remote.

Notes:

•When the 6.1 Ch. Input is in use, you may not select a surround mode, as the external decoder determines processing.

•In addition, there is no signal at the record outputs when the 6.1 Ch. Input is in use.