FRONT LOADER ASSEMBLY
PRESSUREand SUCTION HYDRAULICHOSE
CONNECTION
4. Removethe pipe plugfrom the valve body
and clean the threads and then install the |
|
|
pressure hose. Remove the plastic caps |
|
|
from the pump outlets. Use sealer on |
|
|
threads and screw the other end (swivel |
| ESSURE HOSE |
connector end) into the threaded pipe |
| |
|
| |
fitting on the pump. Slidethe suction hose |
|
|
(large hose) over the pipe end at the | HOSE CLAM |
|
bottom of mastkeservoirand pipe end on |
|
|
the pump. Attach with hose clamps and |
|
|
tighten securely. |
|
|
| PUMP | w,SUCTION HOSE |
5. Attach the front guard on the front of the
112inch nuts and washers. Do not tighten bolts at this time.
AlTACHlNG LOADING MASTS
6.Move the tractor until the masts 'are positioned over the upright pads on the
NOTE: Masts may haveto be shaken to align fixing pin holes.
FIXING PIN. | \IF |
20