OPERATIONAL CHECK
OPERATIONAL CHECK
Check all pivot points on the loader. Lubricate as necessary.
(See lubrication chart.) on page number 44
Check loader hydraulic fluid.
Note: Check fluid level with loader arms down and bucket flat on the ground.
Remove oil check screw and see if oil will run out hole. (Do not overfill)
If oil level is low, remove oil fill plug and add hydraulicfluid until it runsout of oil check hole.
Operate andcheckthe loadermainframe and bucket for interference, noise, and bendingof
parts.
using loader, double | |
check: |
|
Tractor Owner's Manualfor recommended tire,pressure
That all bolts and hoses have been tight- ened and that all tools have been removed from tractor and loader.
Counterweights are Installedand correct.
START UP PROCEDURE
Ensure tractor meets all requirements in Tractor PreparationSection.
Check front loader hydraulicfluid level. Refer to front loader operator's manual.
Note: Bucket and lift cylinders should be fully retractedwhen checking hydraulicfluid level:
Check all hydraulic hose connections to ensure that they are not leaking.
Lubricate all pivot points that incorporate grease fittings.
Start tractor and run engine at approximately 1200 - 1400 RPM for initial cycling of loader.
Push PTO lever forward to "ON"
1 - | |
|
the first time, cycle lift and bucket cylindersto purge air from cylinder. Air in the hydraulic system can cause unexpected fall of main frame, causing Injury or damage to loader or tractor.
Cycle lift and bucket cylinders with bucket empty several times to
Check all hydraulic hose routings to ensure adequate clearances exist between hoses and adjacent components.
1 -
25