Honeywell 6039 owner manual To clean or replace paper air filter

Page 16

Maintenance

Figure 15 - Battery Connections

The engine will not run properly and may be damaged if using a dirty air filter. Clean or replace the air filter paper filter once a year. Clean or replace more often if operating under dusty conditions (Figure 16).

To clean or replace paper air filter:

1.Remove air filter cover and remove paper filter.

2.Clean paper filter by tapping it gently on a solid surface. If the filter is too dirty, replace it with a new one. Dispose of the old filter properly. The air filter part number is 0G84420151.

3.Clean air filter cover, then insert new paper filter into the base of the air filter. Re-install air filter cover.

NOTE:

To order a new air filter, please contact the nearest authorized service center at 1-855-GEN-INFO.

Figure 16 - Air Filter

The engine exhaust muffler has a spark arrestor screen. Inspect and clean the screen at least once each year (Figure 17). If unit is used regularly, inspect and clean more often.

If using the generator on any forest-covered, brush-covered or grass-covered unimproved land, it must be equipped with a spark arrestor. The spark arrestor must be maintained in good condition by the owner/operator.

Clean and inspect the spark arrestor when the engine is at ambient temperature as follows:

1.Remove the spark arrestor screen from the muffler by loosening the clamp and removing the screw.

2.Inspect screen and replace if torn, perforated or otherwise damaged. DO NOT USE a defective screen. If screen is not damaged, clean it with commercial solvent.

3.Replace the spark arrestor and secure with the clamp and screw.

NOTE:

To order a new air filter or spark arrestor screen, please contact the nearest authorized service center at 1-800-333-1322.

Figure 17 – Spark Arrestor Screen

14

Image 16
Contents Portable Generator Table of Contents Introduction Avoided, could result in death or serious injurySafety Rules Exhaust & Location HazardsModel no Serial no – Handle Assembly General Information– Wheel Assembly OperationGenerator Controls 120/240 VAC, 30 Amp Receptacle Grounding the Generator Clean area around fuel fill cap, remove cap Install fuel cap and wipe up any spilled gasoline• Below 10 F, use synthetic 5W-30 YIP 3238*MPP%FSZI0MTEngine ON/OFF Switch Maintenance Move Run/Stop switch to OFF position Close fuel valveCheck Valve Clearance Every Season Service Air Filter Check Oil Level At Each Use Change Oil ‡Replace Spark Plug Every Season • Air Induction System • Ignition SystemSpark Plug Gap To clean or replace paper air filter Remove air filter cover and remove paper filterAvoid spray from spark plug hole when cranking engine Troubleshooting Problem Cause CorrectionPage Warranty BOX 297 WHITEWATER, WIEmission Related Parts MAY Include the Following if Equipped Generac Power SYSTEMS, INC Ignition Coils / Module Warranty Schedule