Honeywell 6039 owner manual Ignition Coils / Module

Page 23

Warranty

EMISSION CONTROL SYSTEM WARRANTY

Emission Control System Warranty (ECS Warranty) for equipment using small spark-ignited engines:

(a)Applicability: This warranty shall apply to equipment that uses small off-road engines. The ECS Warranty period shall begin on the date the new equipment is purchased by/delivered to its original, end-use purchaser/owner and shall continue for the lesser of:

(1)The period of time specified in the Generac Limited Warranty enclosed herewith, but not less than 24 months, or

(2)For engines equipped with hour meters, a number of operating hours equal to half of the engine’s useful life. The useful life is specified on the Emissions Control Label on the engine.

(b)General Emissions Warranty Coverage: Generac warrants to the original, end-use purchaser/owner of the new engine or equipment and to each subsequent purchaser/owner that the ECS when installed was:

(1)Designed, built and equipped so as to conform with all applicable regulations; and

(2)Free from defects in materials and workmanship which cause the failure of a warranted part at any time during the ECS Warranty Period.

(c)The warranty on emissions-related parts will be interpreted as follows:

(1)Any warranted part that is not scheduled for replacement as required maintenance in the Owner's Manual shall be warranted for the ECS Warranty Period. If any such part fails during the ECS Warranty Period, it shall be repaired or replaced by Generac according to Subsection (4) below. Any such part repaired or replaced under the ECS Warranty shall be warranted for the remainder of the ECS Warranty Period.

(2)Any warranted part that is scheduled only for regular inspection as specified in the Owner's Manual shall be warranted for the ECS Warranty Period. A statement in the Owner’s Manual to the effect of "repair or replace as necessary" shall not reduce the ECS Warranty Period. Any such part repaired or replaced under the ECS Warranty shall be warranted for the remainder of the ECS Warranty Period.

(3)Any warranted part that is scheduled for replacement as required maintenance in the Owner's Manual shall be warranted for the period of time prior to first scheduled replacement point for that part. If the part fails prior to the first scheduled replacement, the part shall be repaired or replaced by Generac according to Subsection (4) below. Any such emissions-related part repaired or replaced under the ECS warranty shall be warranted for the remainder of the period prior to the first scheduled replacement point for that part.

(4)Repair or replacement of any warranted, emissions-related part under this ECS Warranty shall be performed at no charge to the owner at a Generac Authorized Warranty Service Facility.

(5)Notwithstanding the provisions of subsection (4) above, warranty services or repairs must be provided at Generac Authorized Service Facilities.

(6)When the engine is inspected by a Generac Authorized Warranty Service Facility, the purchaser/owner shall not be held responsible for diagnostic costs if the repair is deemed warrantable.

(7)Throughout the ECS Warranty Period, Generac shall maintain a supply of warranted emission-related parts sufficient to meet the expected demand for such parts.

(8)Any Generac authorized and approved emission-related replacement parts may be used in the performance of any ECS Warranty maintenance or repairs and will be provided without charge to the purchaser/owner. Such use shall not reduce Generac ECS Warranty obligations.

(9)No modifications, other than those explicitly approved by Generac, may be made to the generator. Unapproved modifications void this ECS Warranty and shall be sufficient ground for disallowing an ECS Warranty claim.

(10)Generac shall not be held liable hereunder for failures of any non-authorized replacement parts, or failures of any authorized parts caused by the use of non-authorized replacement parts.

EMISSION RELATED PARTS MAY INCLUDE THE FOLLOWING (IF EQUIPPED):

1)

FUEL METERING SYSTEM

3)

IGNITION SYSTEM

 

A.

CARBURETOR AND INTERNAL PARTS

 

A.

SPARK PLUGS

 

B.

FUEL TANK / CAP

 

B.

IGNITION COILS / MODULE

 

C.

FUEL LINES

4)

AIR INJECTION SYSTEM

 

D.

EVAPORATIVE VENT LINES

 

A.

PULSE AIR VALVE

 

E.

REGULATOR (GASEOUS FUELS)

5)

EXHAUST SYSTEM

 

F.

CARBON CANISTER

 

A.

CATALYST

2)

AIR INDUCTION SYSTEM

 

B.

EXHAUST MANIFOLD

A.INTAKE MANIFOLD

B.AIR FILTER

Part 2 of 2

Part No. 0J8147C Rev. A 01/12

 

21

Image 23
Contents Portable Generator Table of Contents Avoided, could result in death or serious injury IntroductionExhaust & Location Hazards Safety RulesModel no Serial no General Information – Handle AssemblyOperation – Wheel AssemblyGenerator Controls 120/240 VAC, 30 Amp Receptacle Grounding the Generator YIP 3238*MPP%FSZI0MT Clean area around fuel fill cap, remove capInstall fuel cap and wipe up any spilled gasoline • Below 10 F, use synthetic 5W-30Engine ON/OFF Switch Move Run/Stop switch to OFF position Close fuel valve Maintenance• Air Induction System • Ignition System Check Valve Clearance Every Season Service Air FilterCheck Oil Level At Each Use Change Oil ‡ Replace Spark Plug Every SeasonSpark Plug Gap Remove air filter cover and remove paper filter To clean or replace paper air filterAvoid spray from spark plug hole when cranking engine Problem Cause Correction TroubleshootingPage BOX 297 WHITEWATER, WI WarrantyEmission Related Parts MAY Include the Following if Equipped Generac Power SYSTEMS, INC Ignition Coils / Module Warranty Schedule