Honeywell 6039 owner manual General Information, – Handle Assembly

General Information

•Remove all packaging material.

•Remove separate accessory box.

•Remove the generator from carton.

Check all contents. If any parts are missing or damaged, locate an authorized dealer at 1-855-GEN-INFO.

•1-Owner’s manual

•1-Bottle of Oil SAE 30

•3-Product Registration Cards (English, Spanish, French)

•1-Oil Funnel

•4-Curved Head Bolts (A)

•4-Acorn Nuts (B)

•2-Small Washers (C)

•2-Rubber Feet (D)

•2-Foot Brackets (E)

•2-Long Hex Head Bolts (F)

•8-Short Hex Head Bolts (G)

•10-Nuts (H)

•1-Axle (J)

•1-Axle Bracket (K)

•2-Wheels (L)

•2-Large Washers (M)

•2-Hair Pins (N)

The generator requires some assembly prior to using it. If problems arise when assembling the generator, please call the Generator Helpline at 1-855-GEN-INFO.

The wheels are designed to greatly improve the portability of the generator. You will need the following tools to properly install the accessory kit:

•Ratchet and a 10mm socket

•10mm box wrench

Refer to the instructions below and figures 1A, 1B, and 1C to install the handles, feet, and wheels. Note: the handle components are already pre-assembled from the factory.

1.Install the handle assembly to the frame by using bolts (A) and nuts (B).

2.Repeat step one for opposite handle.

3.Place washer (C) inside rubber foot (D). Secure parts to bracket (E) with bolt (F) and nut (H).

4.Install foot assembly to the frame using the short bolts (G) and nuts (H).

5.Repeat steps 3 & 4 for other foot.

6.Use four short bolts (G) and four nuts (H) to secure the axle

(J) & bracket (K) to the frame.

7.Slide wheel (L) and washer (M) onto axle (J). Secure parts with pin (N).

8.Repeat steps 6 & 7 for the opposite wheel.

Figure 1A – Handle Assembly

Figure 1B – Foot Assembly

4