BODEGA BAY WOOD INSERT
INSTALLATION IN CANADA
MASONRY and HEAT-CIRCULATING
(INSTALLATIONS INTO
R
Whether installed in a masonry or
•Do not remove bricks or mortar from fireplace to accommodate insert.
•The face of the fireplace must be sealed to prevent room air passage into the chimney cavity.
•The permanent metal warning label provided must be affixed to the back of the fireplace with screws or nails to the fireplace, in a location readily visible should the fireplace insert by removed, stating that the fireplace may have been altered to accommodate the insert, and must be returned to original condition for use as a conventional fireplace.
•Circulating air chambers may not be blocked.
Leveling Bolts and sheet metal shims
The insert is shipped with 2 leveling bolts and 2 sheet metal guides for ease in sliding the insert into place when using the leveling bolts. Not all installations will require the use of the leveling bolts. The sheet metal guides are used only when the leveling bolts are necessary. Discard if not needed.
Leveling Bolt |
Reach between side of insert and outer skin
Figure 11A
SHEET METAL GUIDES
Slide each guide under the insert on each side placing them directly under leveling bolts. If they are not directly under the bolts, the bolts may hang up on uneven material when sliding the insert into place. See Figure 11B.
ADUSTING THE LEVELING BOLTS
It is best to use a 1/2” (12.7mm) socket wrench with an extended handle for ease in adjusting bolts to the desired level. The bolts will adjust from 0 inches to 2 inches (0 - 51mm). You can also reach in and adjust the bolts by hand, although space is limited. See Figure 11A.
Sheet Metal Shims
Place under leveling bolts and slide insert into place
Leveling Bolts
Figure 11B
August 20, 2008 | Page 11 |