Door Handle Assembly

BODEGA BAY WOOD INSERT

PANEL and GOLD or NICKEL TRIM SET

STANDARD: 30-1/2” h x 44-5/8”w

LARGE: 34”h x 50-1/2”w

SP-BB3044-GD	Panel & Trim Set, Std, Gold
SP-BB3044-NL	Panel & Trim Set, Std, Nickel
SP-BB3450-GD	Panel & Trim Set, Large, Gold
SP-BB3450-NL	Panel & Trim, Set, Large, Nickel

Included in Panel Kit: (2) side panels, left and right; (1) panel top; (2) trim sides, left and right; (1) trim top (1) fastener package.

Tools Needed: Powered Phillips head Screw Driver

1.Remove contents from box being careful not to scratch or damage trim pieces.

2.Lay the panel set face down on protective covering to prevent scratching the painted surface.

3.Secure panel set together with screws provided. See

Figure 13A

4.To assemble the trim, attach the 2 side trim pieces to the top trim at each corner using the “L” bracket included in fasteners package. See Figure 13B

5.Slide panel and trim as 1 piece over top of the insert and into position.

6.Secure panel set to insert. See Figure 13A.

Tab with screw hole to secure panel to insert

Figure 13A

View of "L" Bracket

installed

Figure 13B

Screw side panels to top panel

Door Latch Arm

Door

Handle

5/16 Nut 1/4-20	Washer,
	5/16 x 1/4

Washer

Fibe

Hand

DOOR LATCH ADJUSTMENT

It is important the door gasket has a proper seal. As the gasket compresses or “seats” during use, it may become necessary to adjust or tighten the door latch.

1.Loosen securing screw (do not remove).

2.Turn adjustment bolts as need for adjustment (in or out) using 7/16” end wrench.

3.Tighten securing screw to hold adjusted position in place.

Securing

Screw

Adjustment Bolts

Figure 13C

Figure 13D

August 20, 2008

435-1320B

Page 13