FUNCTIONS | NAMES AND |
CONNECTIONS | BASIC |
OPERATION | BASIC |
CONNECTIONS | ADVANCED |
SETUP | |
OPERATION | ADVANCED |
TROUBLESHOOTING | |
OTHERS |
ENGLISH
BASIC OPERATION
AMP OPERATION
The unit shown in the illustrations is SR6004.
TURNING ON THE UNIT
1. Turn the power of the equipment connected to this unit on.
2. Press the POWER ON/STANDBY button of this unit. Every time the button is pressed, the power to this unit toggles between on and standby.
To activate power using the remote controller, press the AMP button, followed by the ON button and SOURCE ON/OFF button of the remote controller.
SELECTING AN INPUT SOURCE
Before you can listen to any input media, you must first select the input source on the unit.
EXAMPLE : DVD
To select DVD, turn the INPUT SELECTOR knob on the front panel or press the DVD button on the remote controller two times in a row. After you have selected DVD, simply turn on the DVD player and play the DVD.
•As the input source is changed, the new input name will appear momentarily an OSD information on the video display. The input name will also appear in the display, on the
•If you use the FUNCTION RENAME feature (see page 26) , the renamed name appears on the display.
•As the input is changed, this unit will automatically switch to the digital input, surround mode, attenuation, and night mode status which were entered during the configuration process for that source.
•When a video source is selected, the selected video signal is output from the MONITOR OUT terminal.
ADJUSTING THE MAIN VOLUME
Adjust the volume to a comfortable level using the VOLUME control knob on the front panel or VOLUME + / – buttons on the remote controller.
To increase the volume, turn the VOLUME knob clockwise or press VOLUME + button on the remote controller, to decrease the volume, turn counterclockwise or press VOLUME – button on the remote controller.
Notes
•The volume can be adjusted within the range of
– ∞ and
•However, when the channel level is set as described on page 32, if the volume for any channel is set at +1 dB or greater, the volume cannot be adjusted up to 18 dB.
(In this case the maximum volume adjustment range is “18 dB - Maximum value of channel level)
ADJUSTING THE TONE (BASS & TREBLE) CONTROL
During a listening session you may wish to adjust the Bass and Treble Control to suit your listening tastes or room acoustics.
(Using the remote controller)
To adjust the tone, press the AMP button.
To adjust the bass effect, press BASS + or BASS
–button.
To adjust the treble effect, TREBLE + or TREBLE
–button.
Notes
The tone control function cannot be used in any of the modes listed below.
•Source Direct
•Pure Direct
•7.1 ch Input
•Dolby Virtual Speaker
•Dolby Headphone
•Dolby True HD
•Dolby Digital Plus
•
•Accoustic EQ
•
TEMPORARILY TURNING OFF THE SOUND
To temporarily silence all speaker outputs such as when interrupted by a phone call, press the MUTE button on the remote controller.
This will interrupt the output to all speakers and the
When the system is muted, the display will show “MUTE” .
Press the MUTE button again to return to normal operation.
16