Marantz SR5004 manual SR6004 Remote Controller Macro Mode, Programming Macros, Confirming Macros

FUNCTIONS	NAMES AND
CONNECTIONS	BASIC
OPERATION	BASIC
CONNECTIONS	ADVANCED
SETUP
OPERATION	ADVANCED

ENGLISH

ADVANCED OPERATION

SR6004 REMOTE CONTROLLER

MACRO MODE

PROGRAMMING MACROS

Macros make it possible to use a single function button to perform more complex series of operations that would normally require pressing several buttons.

A single MACRO can be programmed to perform up to 10 steps in sequence.

A typical example of such a series might be as follows:

•Turn this unit’s power on

↓

•Switch this unit's input source to DVD

↓

•Turn the TV’s power on

↓

• Set the DVD player to play.

• No signals may be transmitted during macro

programming.

• The various steps that make up a macro are

set initially to be sent one after another in 1

second intervals, however these intervals may

be shortened to as little as 0.5 seconds or

lengthened to as much as 5 seconds using the

setup mode.

• In the macro mode, the number of steps the

macro is displayed with Macro list number.

• Macros may be programmed 6 list.

PROGRAM METHOD OF MACRO

1.

3.

4.

3. 1.

2.

1. Press and hold the SET and MACRO button until the LEARN, MACRO indicators and MACRO are displayed blinking on the LCD.

2. Press the numeric button for which you wish to program a series of operations. Press the 1 button.

• “M1-01” is displayed on the LCD.

Press 2 Button (Fixed 1st step)

•The number of steps in the macro is displayed on LCD and this number increases by 1 with each button pressed.

•Each macro number can be programmed to perform up to 10 steps in sequence.

Note

When programing the amplifierʼs input source in the macro program, first press the AMP button, and press the source button.

(In the case of DVD input: AMP → DVD)

4. When you are finished programming macros, press and hold the ENTER button until the display returns to normal mode (Turn off the LEARN and MACRO indicators).

•In the macro mode, it is possible to program the memory to perform macros containing up to 10 steps.

•Macros cannot be programmed for the MEMO, cursor, ENTER, VOLUME+/– and CLR buttons.

CONFIRMING MACROS

Macros may be confirmed using following procedure.

3.

5. 1.

1. 2.

1. Press and hold the MACRO and MENU buttons until the LEARN, MACRO indicators and MACRO are displayed blinking on the LCD.

2. Press the numeric button to be confirmed. Let’s use the example of macro number 1, by pressing “1” button.

•LEARN, MACRO indicators and M1-01 are displayed blinking.

TROUBLESHOOTING

OTHERS

MACRO button + numeric button (Example :

Macro list No.1 → MACRO button + “1”)

•If selected macro number has already been set the program, the LCD will blink.

3.Press the function buttons and command button for the operations you wish to program as a macro in the sequence.

For example, press DVD button and 2 button.

Press DVD Button (DVD Function)

↓

3. Press the VOLUME button.

• M1-01 is displayed and LEARN is disappeared.

	• T h e p r o g r a m m e d o p e r a t i o n i s
Note	transmitting.

If, while programming, no buttons are pressed for approximately 1 minute, the remote controller will automatically return to normal mode, and no macro will be programmed in the memory.

72