Ford 58064 owner manual Heat Sinks

Page 10

TRAXXAS TQ 2.4GHZ RADIO SYSTEM

XL-5 Wiring Diagram

Your model is equipped with the Traxxas TQ 2.4GHz transmitter. The transmitter has two channels: Channel one operates the steering, and channel two operates the throttle. The receiver inside the model has three output channels. Your model is equipped with one servo and an electronic speed control.

TRANSMITTER AND RECEIVER

Steering Wheel

Red/Green Status LED

Set Button

Steering

Trim

Throttle

Trigger

MODEL WIRING DIAGRAM

	Antenna	Motor
	Antenna	(Titan® 12T)
		(Titan® 12T)
	Receiver

XL-5 Electronic

Speed Control

Channel 2

CH3 - Channel 3*		Traxxas High-Current
CH2	- Speed Control
		Connector (Male)
CH1	- Steering Servo
		to Battery
CH1	- Channel 1*

*not used

Steering Servo

Channel 1

XL-5 ELECTRONIC SPEED CONTROL

To Motor

Traxxas High-Current

Connector (Male)

to Battery

10 • RAPTOR

Heat Sinks

Power Switch		Battery Compartment

LED	Set Button

Image 10

Contents Model Traxxas Support IntroductionQuick Start Traxxas Before YOU ProceedMost importantly, use good common sense at all times Batteries and Battery Charging 5mm L wrench 0mm L wrench Joint wrench Safety glassesTOOLS, SUPPLIES, and Required Equipment AA alkaline BatteriesElectronic Speed Control Rear Camber Link LED Light Pipe Anatomy of the RaptorFront Shock Tower Quick Start Getting UP to Speed Radio and Power System Terminology IntroductionImportant Radio System Precautions Correct No No No NoHeat Sinks Charging the Battery Pack Installing Transmitter BatteriesFor faster charging, the included battery may be charged at Traxxas High-Current Connector Installing the Battery PackUsing a Different Battery Configuration Battery, Power Cell, 3000mAh NiMH, 7-C flatRadio System Controls Steering reversing procedureThrottle reversing procedure Steering TrimElevate the model so that the rear tires are off the ground Range-Testing the Radio SystemHigher Speeds Require Greater Distance TQ 2.4GHz Binding Instructions Setting UP the AntennaAntenna wire Screw it onto the antenna postAdjusting the Electronic Speed Control LED Codes and Protection Modes XL-5 Profile SelectionProfile Description Recalibrating XL-5 Speed ControlDriving Your Model Receiver Installation Motor PrecautionsRemoving and Installing Radio Gear After Running Your Vehicle in Wet ConditionsFine Tuning the Shocks Adjusting Your ModelAdjusting the Toe-in Shock Mounting PositionsAdjusting Gear Mesh Adjusting the Slipper ClutchGearing Compatibility Chart Motor and GearingStorage Other periodic maintenanceMaintaining Your Model Slipper clutch pads friction materialModel