Marantz SR6005 Retrieving Audyssey Auto Setup settings, Press Return, Examples Error details

Parameter Check

This function enables you to check the measurement results and equalizer characteristics after Audyssey Auto Setup.

1 Use ui to select “Parameter Check” and then press ENTER or p.

2 Use ui to select the item you want to check, then press ENTER or p.

Measurement results for each speaker are displayed.

SVENSKA NEDERLANDS ESPAÑOL ITALIANO FRANÇAIS DEUTSCH ENGLISH

Error messages

An error message is displayed if Audyssey® Auto Setup could not be completed due to speaker placement, the measurement environment, etc.

If this happens, check the relevant items, be sure to take the necessary measures, then perform Audyssey Auto Setup over again.

NOTE

Be sure to turn off the power before checking speaker connections.

Simple version

Examples Error details Measures

AUTO SETUP			• The connected setup microphone is broken,	• Connect the included setup microphone to
AUDYSSEY AUTO SETUP		MultEQ	or a device other than the supplied setup	the SETUP MIC jack of this unit.
	Caution!		microphone is connected.
	No microphone or Speaker		• Not all speakers could be detected.
			• The front L speaker was not properly	• Check the speaker connections.
			detected.
	Retry
Check cause of problem!		RETURN Cancel
AUTO SETUP			• There is too much noise in the room for	• Either turn off any device generating noise
AUDYSSEY AUTO SETUP		MultEQ	accurate measurements to be made.	or move it away.
	Caution!			• Perform again when the surroundings are
	Ambient noise is too high			quieter.
	or Level is too low
			• Speaker or subwoofer sound is too low for	• Check the speaker installation and the
			accurate measurements to be made.	direction in which the speakers are facing.
	Retry			• Adjust the subwoofer’s volume.
Check cause of problem!		RETURN Cancel
AUTO SETUP			• The displayed speaker could not be detected. • Check the connections of the displayed
AUDYSSEY AUTO SETUP		MultEQ		speaker.
Caution!
Front R	None
Retry
Check cause of problem!		RETURN Cancel
AUTO SETUP			• The displayed is connected with the	• Check the polarities of the displayed
AUDYSSEY AUTO SETUP		MultEQ	polarities reversed.	speaker.
Caution!				• For some speakers, this error message may
Front L	Phase			be displayed even if the speaker is properly
				connected. If you are sure the connection is
				correct, press ui to select “Skip”, then
Retry				press ENTER.
Skip
Check cause of problem!		RETURN Cancel

AUTO SETUP

PARAMETER CHECK

Speaker Config Check

Distance Check

Channel Level Check

Crossover Check

EQ Check

Restore

Show speaker configuration result

	Check the speaker configuration.
Speaker Config. Check
	Check the distance.
Distance Check
	Check the channel level.
Channel Level Check
	Check the crossover frequency.
Crossover Check
	Check the equalizer.
EQ Check

•If “EQ Check” is selected in step 2, press ui to select equalizing curve (“Audyssey” or “Audyssey Flat”) to be checked.

Use o p to switch the display between the different speakers.

3 Press RETURN.

The confirmation screen reappears. Repeat steps 2.

Retrieving Audyssey Auto Setup settings

If you set “Restore” to “Yes”, you can return to Audyssey Auto Setup measurement result (value calculated at the start by MultEQ®) even when you have changed each setting manually.

Basic version

Advanced version

Information

Remote control operation	Move the cursor	Confirm the setting	Return to previous menu	11
buttons	(Up/Down/Left/Right)