Echo ES-250 specifications Shred ‘ N’ VAC Operation, Read the Safety Section carefully

Page 19

ES-250

OPERATION

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Always wear safety glasses, hearing protection and a face filter mask or serious personal injury may result. Do not point the blower pipe in the direction of people or pets.

Use reduced speed only when performing light-duty tasks or to comply with local noise regulations. Continuous low speed operation may allow fuel/oil residue to build-up on the piston and cause rapid build-up of carbon on the spark arrestor screen, resulting in overheating and engine damage. To reduce harmful build-up, run engine at wide open throttle for at least 5 minutes every hour, and inspect/clean the spark arrestor screen after approximately 40 hours of operation.

Read the Safety Section carefully.

To avoid engine damage due to over-revving, do not block blower pipe.

1.Use only during appropriate hours.

2.Allow the engine to warm up at a fast idle for a few minutes.

3.Control engine speed with throttle trigger (F), or for continuous use, set engine speed with throttle position lever (B). Rotate throttle position lever forward for lower speed, back for higher speed.

4.Use lower speed to blow debris from hard surfaces.

5.Additional speed may be necessary to clean debris, snow, etc. from lawns and flowerbeds.

Note: Never use a higher speed setting than necessary to perform a task. Remember, the higher the engine speed, the louder the blower noise. Minimize dust by using blower at lower speeds. Keep debris on your property. Be Smart - be a good neighbor.

SHRED ‘ N’ VAC® Operation

Flying debris hazard. Never operate unit as a vacuum unless discharge elbow is installed and debris bag is securely cinched to elbow. Failure to follow instructions can result in serious injuries.

X7501182803

19

© 03/2013 ECHO Inc.

Image 19
Contents Burn Hazard Operator’s ManualTable of Contents Servicing Information IntroductionManual Safety Symbols and Important Information SafetyInternational Symbols Personal Condition and Safety Equipment Repetitive Stress Injuries Vibration and ColdEquipment EPA 2010 and Later and/or C.A.R.B. Tier Emission Control Exhaust & EvaporativeProduct Emission Durability Emission Compliance Period Description Description Contents Install Blower Pipes AssemblyBlower Application Vacuum/Shredding Application Install Vacuum TubeInstall Bag Remove Blower PipesX7501182803 Handling Fuel OperationFuel Fuel RequirementsAfter use Starting Cold EngineThrottle Trigger Starting Warm EngineOperating Blower Stopping EngineShred ‘ N’ VAC Operation Read the Safety Section carefullyProblem Cause Remedy Shred ‘ N’ VAC TroubleshootingMaintenance Intervals MaintenanceSkill Levels Fuel Filter Air FilterSpark Plug Cleaning GrillCooling System Spark Arrestor Screen Cleaning Cylinder FinsExhaust Port Cleaning Exhaust SystemEngine Break-In Carburetor AdjustmentHigh Altitude Operation Debris Bag Shredder BladeEngine Problem Troubleshooting Chart TroubleshootingLong Term Storage Over 30 Days StorageModel SpecificationsOWNER’S Responsibility Warranty StatementsWarranty Statements ES-250 ES-250 ES-250 ES-250