Echo ES-250 specifications Long Term Storage Over 30 Days

Page 28

STORAGE

ES-250

 

 

STORAGE

During operation the muffler or catalytic muffler and surrounding cover become hot. Always keep exhaust area clear of flammable debris during transportation or when storing, otherwise serious property damage or personal injury may result.

Long Term Storage (Over 30 Days)

Do not store your unit for a prolonged period of time (30 days or longer) without performing protective storage maintenance which includes the following:

1. Store unit in a dry, dust free place, out of the reach of children.

Do not store in enclosure where fuel fumes may accumulate or reach an open flame or spark.

2.Place the stop switch in the “OFF” position.

3.Remove accumulation of grease, oil, dirt and debris from exterior of unit.

4.Perform all periodic lubrication and services that are required.

5.Tighten all the screws and nuts.

6.Drain fuel tank completely. Press purge bulb 6 -7 times to remove remaining fuel from carburetor then drain the tank again. Close choke, start and run the engine until it stops due to lack of fuel.

7.

a.Allow engine to cool then remove the spark plug and pour 7 cc (1/4 oz.) of fresh, clean, two-stroke engine oil into the cylinder through the spark plug hole.

b.Pull the recoil starter handle 2-3 times to distribute the oil inside the engine.

c.Observe the piston location through the spark plug hole. Pull the recoil handle slowly until the piston reaches the top of its travel and leave it there.

8.Install the spark plug (do not connect ignition cable).

9.Remove blower pipe assembly from unit.

28

X7501182803

© 03/2013 ECHO Inc.

Image 28
Contents Operator’s Manual Burn HazardTable of Contents Introduction Servicing InformationManual Safety Symbols and Important Information SafetyInternational Symbols Personal Condition and Safety Equipment Vibration and Cold Repetitive Stress InjuriesEquipment EPA 2010 and Later and/or C.A.R.B. Tier Emission Control Exhaust & EvaporativeProduct Emission Durability Emission Compliance Period Description Description Contents Install Blower Pipes AssemblyBlower Application Install Vacuum Tube Install BagRemove Blower Pipes Vacuum/Shredding ApplicationX7501182803 Operation FuelFuel Requirements Handling FuelStarting Cold Engine After useStarting Warm Engine Throttle TriggerStopping Engine Operating BlowerRead the Safety Section carefully Shred ‘ N’ VAC OperationShred ‘ N’ VAC Troubleshooting Problem Cause RemedyMaintenance Intervals MaintenanceSkill Levels Air Filter Fuel FilterSpark Plug Cleaning GrillCooling System Cleaning Cylinder Fins Exhaust Port CleaningExhaust System Spark Arrestor ScreenEngine Break-In Carburetor AdjustmentHigh Altitude Operation Shredder Blade Debris BagTroubleshooting Engine Problem Troubleshooting ChartStorage Long Term Storage Over 30 DaysSpecifications ModelWarranty Statements OWNER’S ResponsibilityWarranty Statements ES-250 ES-250 ES-250 ES-250