MAINTENANCE
Battery
Your mower is equipped with a maintenance free battery and does not need servicing. However, periodic charging of the battery with an automotive type battery charger will extend its life.
•Keep battery and terminals clean.
•Keep battery bolts tight.
•Recharge at
To clean battery and terminals
Corrosion and dirt on the battery and terminals can cause the battery to “leak” power.
1.Lift seat and rotate forward.
2.Disconnect BLACK battery cable first, then the RED battery cable and remove the battery from the machine.
3.Rinse the battery with plain water and dry.
4.Clean terminals and battery cable ends with wire brush until shiny.
5.Coat terminals with grease or petroleum jelly
6.Reinstall battery.
Replacing battery
1.Lift seat and rotate forward.
2.Open terminal access doors.
3.Using two ½" wrenches disconnect BLACK battery cable then RED battery cable.
4.Position deck to lowest setting.
5.Front underside of frame, remove the nuts that secure the battery
6.Carefully remove the battery from the mower.
7.Install new battery with terminals in the same position as the old battery.
9.Reinstall battery
9.First connect RED battery cable to positive
(+) battery terminal with hex bolt and hex nut.
10.Connect BLACK grounding cable to negative
11.Tighten securely.
12.Lower seat
Always use protective glasses 
when handling the battery.
IMPORTANT INFORMATION!
Do not attempt to open or remove caps or covers. Adding or checking level of electrolyte is not necessary.
Always use two wrenches for the terminals screws.
WARNING!
Do not short battery terminals by allowing the wrench to contact both terminals at the sametime. Before connecting battery, remove metal bracelets, wristwatch bands, rings, etc. Positive terminal must be connected first to prevent sparks from accidental grounding.
Remove battery