SPECIFICATIONS
Model ZTR 5425
CHASSIS: | 11 GA - rectangular tube |
| |
BODY: | Two piece - made of rotational molded polyethylene. Front | body | |
| contains access panels for battery service and engine to mower deck | ||
| belt removal. Rear body tilts up to allow service on the entire drive | ||
| system. |
|
|
SEAT: | Designed for operator comfort by use of high density closed cell foam | ||
| padded back rest and arm rests, upholstered with CorduraTM | water- | |
| repellent fabric. Seat is adjustable fore and aft. |
| |
MOWER DECK: | 13 ga stamped steel construction. 3 blades combine for a 42" cut width. | ||
| Cut height | approximately 1.5" to 4.5" via 7 position lift handle. |
|
BLADE DRIVE: | Electric clutch |
| |
DRIVE SYSTEM: | Each rear wheel is independently driven by a HydroGear | ||
| Series 70 hydrostatic transmission. The hydrostatic transmissions, in | ||
| turn, power a fully enclosed HydroGear gearbox. |
| |
ENGINE: | 17HP Briggs & Stratton Intek, overhead valves, replaceable oil filter, | ||
| full pressure lube system, dual element air cleaner, integral fuel pump. | ||
STARTING SYSTEM: | Electric by key switch operation with safety interlocks on parking brake | ||
| and blade drive clutch. |
| |
TIRES: | Front | 11 X 4 X 5 smooth profile |
|
| Rear | 18 X 9.5 X 8 Multi Trac |
|
RECOMMENDED | Front | 16 - 21 lbs. |
|
TIRE PRESSURE: | Rear | 8 - 14 lbs. |
|
CAPACITIES: | Fuel - 4.8 gallons total (dual tanks) |
| |
| Hydrostat oil tank - 3 quart with |
| |
| Hydrostat oil recommendation, refer to page 36 |
| |
| Engine - 2 qts. SAE 30 (with filter) |
| |
DIMENSIONS: | Width | 54" |
|
| Height | 45" |
|
| Length | 72" |
|
| Weight | 615 lbs |
|
NOTE: | Additional information provided in service instructions under the | ||
| individual component. |
| |
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
Page 13