![](/images/new-backgrounds/1146741/14674129x1.webp)
Beginning Assembly |
| Install Support Leg |
|
|
|
|
|
|
This section will cover the minimum assembly and adjustment instructions needed to begin operation. For best results, complete the assem- bly in the order provided in this manual and then read the remaining portion of the manual before attempting any type of operations.
Do not connect the machine to power at this time. The machine must
remain unplugged throughout the entire assembly process. Failure to do this may result in serious personal injury.
To install the support leg:
1.Get the help of an assistant.
2.Tip the lathe forward and have your assistant thread the leg w/attached foot into the lathe stand as shown in Figure 4.
Jam Nut
Leg Support
Figure 4. Installing support leg.
3.Adjust the support leg until it just makes con- tact with the surface of your workbench or stand.
4.Tighten the jam nut so the leg will not move.
|
|
|
|
|
|
|
|
|
|
|
|
G0516 Lathe/Mill |