12.Bed Guide
13.Cross Slide Leadscrew
14.Bed Guide
15.Bed Guide
16.Apron
17.Cross Slide Leadscrew Support
18.Apron
19.Bed Guide
20.Bed Guide
21.Bed Guide
21
12
13
20
14 
19
15
18
16
3 | 17 |
Figure 64. Ball fitting lubrication points.
Gears—Apply a minimal amount of oil to the teeth of the end gears after assembly and each 8 hours of actual use. Avoid getting oil on the belt or pulleys when lubricating. Also, regularly apply lubrication to all the ball fittings drive box.
Long Leadscrew—Apply a minimal amount directly on the rack every 8 hours of actual use.
Carriage Rack—Apply a minimal amount direct- ly on the rack every 8 hours of actual use.
Mill/Drill Rack & Pinion—Apply a minimal amount directly on the rack every 8 hours of actual use.
Checking V-Belt
To ensure optimum power transmission from the motor, the
The check the V-belt:
1.Unplug the lathe/mill from its power source!
2.Open the drive cover.
3.Note the condition of the
|
|
| G0516 Lathe/Mill |
|
|
| |
|
| ||
|
|
