![](/images/new-backgrounds/1146741/14674159x1.webp)
Changing Gears For Carriage Feed Rate
To learn how to change gears, change the cur- rent gear setup to the .010" feed rate that is shad- ed in Figure 36.
|
| 0.005" 0.010" | |
C | B | 35 80 | 50 80 |
D | E | 90 30 | 66 30 |
| F | 100 | 100 |
Figure 36. .010" feed rate setup (shaded).
To change the carriage feed rate to .010" per spindle revolution:
1.Disconnect the lathe/mill from the power source!
2.Loosen the knurled knob shown in Figure 37, and open the drive cover.
Drive Cover Knob
Figure 37. Knurled drive cover knob.
3.Hold the adjustable shaft in place with the shaft wrench and use a 19mm wrench to remove the hex nuts on the upper and lower adjustable shafts as shown in Figure 38.
Figure 39. Removing hex nuts from adjustable
shafts with a 19mm wrench.
4.Slide the special lock washer off of each adjustable shaft as shown in Figure 40.
Figure 40. Removing special lock washers from
adjustable shaft.
G0516 Lathe/Mill |