3.Insert the end of the dead center into the tail- stock barrel, as shown in Figure 18, until it seats tight enough that it will not rotate when turned by hand.
4.Tighten the barrel lock to prevent the tail- stock barrel from moving during operation.
Figure 18. Inserting dead center into
tailstock barrel.
Removing Tailstock
Dead Center
To remove the tailstock dead center:
1.Use the barrel handwheel to move the tail- stock barrel all the way back into the tailstock until the handwheel will no longer turn.
2.Pull the dead center out of the tailstock bar- rel.
Adjusting Tailstock Longitude Position
The tailstock on the Model G0516 clamps to the bed with the nut shown in Figure 19. This nut allows the tailstock to be positioned longitudinally along the bed and then locked in place.
Figure 19. Tailstock clamp bolt.
To adjust the tailstock longitude position:
1.Use a 17mm wrench to loosen the tailstock clamp bolt.
2.With your hands, move the tailstock into position along the bed.
3.Tighten the tailstock clamp bolt to secure the tailstock into position.
|
|
|
|
|
|
|
|
|
|
|
|
G0516 Lathe/Mill |