Installing Mill Table
The Model G0516 includes a milling table as an accessory. When the Model G0516 is shipped from the factory, the compound slide is mounted on the cross slide and must be removed before the milling table can be installed. Once installed, the milling table moves back and forth with the cross slide.
To install the mill table:
1. Use a 12mm wrench to remove the two bolts that secure the compound slide to the cross slide. See Figure 59.
Figure 59. Removing compound slide bolts.
2. Remove the compound slide from the cross slide.
3. Place the milling table on the cross slide so the mounting bolts line up with the threaded holes.
4.Secure the milling table to the cross slide, using a 6mm allen wrench with the table mounting cap screws. Figure 60 shows the milling table installed on the cross slide.
