![](/images/new-backgrounds/1146741/14674189x1.webp)
Figure 73. Adjusting for tailstock end taper.
7.Loosen the tailstock clamp nut and the lock screw shown in Figure xx.
Bearing Preload
This lathe is shipped from the factory with the bearing preload already set. If the preload requires resetting for whatever reason, please contact our service department for further instructions.
Tailstock
Clamp Nut
Adjustment
Screw
(one side)
Tailstock
Lock Screw
Figure 74. Tailstock offset adjustment screw.
8.Use the tailstock adjustment screws on both sides to adjust move the tailstock offset by the amount of the taper.
9.Tighten the clamp nut, lock screw and adjust- ment screws. Be careful not to move the tail- stock out of position when tightening the adjustment screws.
10.Turn another .010'' off of the stock and check for taper. Repeat steps 7-9 as necessary until the desired amount of accuracy is achieved.
|
|
|
|
|
|
|
|
|
|
|
|
G0516 Lathe/Mill |