® 3
IN THE WALL BEZEL REPLACEMENT
WALL CONTROL AND HARDWARE (not to scale)
Switch Mounting
Screws (2)
Switch Bezels |
|
| Wall Plate | (4) Wire Cap | |
White Wall | Almond Wall | Screws |
| ||
Wall Control | (1) White |
| |||
Plate(1) | Plate(1) | (2) White |
| ||
| (1) Almond |
| |||
|
|
| (2) Almond |
| |
|
|
|
|
|
WARNING!
To avoid possible electrical shock, make cer- tain that electricity is turned off at the circuit breaker or fuse box before attempting any in- stallation or repair procedure
CAUTION! NOT turning the power OFF at the circuit breaker or fuse box may cause damage to the electronics within the wall control and/ or the PC board on the fan.
SCREWS
(2)
White Wall
Step 1a. Locate the two (2) screws holding the switch plate to the wall control and remove the cover plate as shown in Figure #1.
Step 1a. Locate the four (4) tabs holding the bezel to the front of the switch, then press in on each tab one at a time, removing the bezel as shown in Figure #2.
Step 1b. Locate the rubber key pad attached to the four (4) locating pins as shown in Figure #2 and remove rubber key pad from the WHITE bezel, also as shown in Figure #2.
Figure #1
BEZEL
BEZEL
TABS
Figure #2
19