®3
|
|
|
|
| OPERATION POWER |
The | button is normally left in the on position. Always turn the power off | |
during cleaning or servicing the fan and during thunderstorms. It is also used to exit or enter additional programs.
The | button must be left on to retain a previously set fan speed or light level. |
OPERATION SPEED CONTROL
There are six individual speed settings for the fan; each speed is indicated by an audible tone of increasing pitch.
To select the desired fan speed:
1.With fan off, press and hold the button labeled 
. The fan blades will start rotating at the slowest speed, and will increase in steps.
2.Release the button when the desired speed is reached.
The fan speed is now in memory and will automatically come on at the
same speed each time the | button is used. To maintain this level | |
of speed, turn the fan on by pressing | less than one second. To | |
lower speed, turn fan off, then on by pressing and holding the 
button until the desired speed is reached. When the fan is on, you may
increase the speed by pressing and holding the | button until the |
desired speed is reached, then release it. |
|
FAN CONTROL
ON - OFF:
A momentary
press of the FAN
button
CHANGE
SPEED:
Press and hold
FAN button
longer than one
second
OPERATION REVERSING AIRFLOW
The direction of airflow can be changed from down- ward to upward or from upward to downward.
To reverse the airflow: |
|
1. Make sure the | is on and blades are Turn- |
ing. |
|
2. Press the | button. |
Note: A
OPERATION LIGHTS
To turn the lights off and on, press and release the | button for less than | ||
one second. |
|
| |
1. | First press/release of the | button- Both lights shall turn ON. | |
2. | Second press/release of the | button- Both lights shall turn OFF. | |
3. Third press/release of the | button – Downlight turns ON only. | ||
4. | Fourth press/release of the | button – Downlight turns OFF. | |
5. | Fifth press/release of the | button – Uplights turns ON only. | |
6. | Sixth press/release of the | button - Uplights turns OFF only. | |
To vary the light brightness at each touch level:
Make sure where you are in the sequence to the right.
To dim both lights at the same time:
1.Make sure you have the uplight on.
2.Turn the light off, then press and hold the 
button. After one second, both lights will come on at their lowest setting and gradually become brighter or dim-
mest level if you continue holding the 
button.
3.Release the 
button when the desired brightness is reached.
LIGHT CONTROL
ON - OFF:
A momentary press of the
LIGHT button
CHANGE BRIGHTNESS:
PRESS AND HOLD
LIGHT BUTTON
LONGER THAN ONE
SECOND
15