Delivery and dealer service
Maintenance schedule
The following is a list of the maintenance which should be conducted on the machine. Most of the points that are not covered by this workshop manual are covered by the operator’s manual.
|
| Daily | Maintenance interval in | |||
Maintenance | Page | maintenance | hours |
|
| |
before | 25 | 50 | 100 | |||
|
| |||||
|
| starting | ||||
Check the oil level in the engine | 12 | ● |
|
|
| |
Check the engine’s cooling air intake | - | ▼ |
|
|
| |
Check the fuel pump’s air filter | - | ▼ |
|
|
| |
Check the steering wires | 29 | ● |
|
|
| |
Check the brakes | 31 | ● |
|
|
| |
Check the battery | 11 | ● |
|
|
| |
Check the safety system | 61 | ● |
|
|
| |
Check the screws and nuts | - | ❍ |
|
|
| |
Check if there is any fuel or oil leakage | - | ❍ |
|
|
| |
Clean around the silencer |
|
|
|
|
| |
Change the engine oil | 28 |
| ●1) |
|
| |
Change the engine oil | 28 |
| ●1) | ●1) |
| |
Clean the air filter’s | - |
| ▼ |
|
| |
Check the mower deck | 47 |
| ● |
|
| |
Check the tyre pressures (60 kPa) | 13 |
| ● |
|
| |
Lubricate the belt tensioner 3) | - |
| ▼ |
|
| |
Lubricate joints and axles 3) | - |
| ▼ |
|
| |
Adjust the brakes, Rider 11 | 31 |
| ● |
|
| |
Check the | - |
| ❍ |
|
| |
Check the transmission’s cooling fins, |
|
|
|
|
| |
Rider 13 and Rider 16 | - |
| ❍ |
|
| |
Check the transmission’s oil level, |
|
|
|
|
| |
Rider 13 and Rider 16 | 44 |
|
| ● |
| |
Adjust the brakes, Rider 13 and Rider 16 | 31 |
|
| ● |
| |
Check and adjust the throttle wire | 26 |
|
| ● |
| |
Clean the cooling fins on the engine and transmission 2,4) | - |
|
| ❍ |
| |
Replace the air filter’s | - |
|
|
| ▼ | |
Replace the fuel filter | - |
|
|
| ▼ | |
Replace the spark plug | 8 |
|
|
| ▼ | |
|
|
|
|
|
|
1)First change after 5 hours. Replace after every 25 hours with heavy loads and high temperatures. 2) Cleaning and replacing should be carried out more frequently in dusty conditions. 3) The machine should be lubricated twice a week if used daily. 4) Carried out by authorised service workshop.
●= Described in this Workshop Manual.
❍= Not described in this Workshop Manual. ▼ = Described in the Operating Instructions.
WARNING!
No service procedures must be conducted on the engine or cutting unit unless:
•The engine is switched off.
•The ignition key is removed.
•The ignition cables are removed from the plugs.
•The parking brake is applied.
•The cutting unit is disengaged.
English – 9