Ariens 911413 warranty Filling the Fuel Tank, Forward Drive Control Lower Right Hand Control

Page 15

Forward Drive Control (Lower Right Hand Control)

CAUTION: Unit will move at engine start if the wheel drive controls are engaged. ALWAYS release the wheel drive controls before starting unit.

NOTE: Engine must be running for wheel drive to propel unit.

To drive forward:

Hold the parking brake lever against the handlebar and slowly squeeze and hold the forward drive control. Hold the forward drive control against the handlebar for fastest speed.

To stop:

Release forward drive control.

Parking Brake

Lever

GO

Forward Drive

ControlSTOP

OM1240

Reverse Drive Control (Side Right Hand Control)

CAUTION: Unit will move at engine start if the wheel drive controls are engaged. ALWAYS release the wheel drive controls before starting unit.

To drive in reverse:

Hold the parking brake lever against the handlebar and slowly squeeze and hold the reverse drive control. Hold the reverse drive control against the handlebar for fastest speed.

To stop:

Release reverse drive control.

Reverse Drive

Control

STOP

GO OM1240

FILLING THE FUEL TANK

To add fuel to fuel tank:

1.Clean fuel caps and surrounding area to prevent dust, dirt, and debris from entering fuel tanks.

2.Remove fuel caps.

IMPORTANT: Refer to Engine Manual for correct type and grade of fuel.

3.Fill fuel tank to the bottom of filler neck (see SPECIFICATIONS on page 28 for fuel tank capacity).

IMPORTANT: DO NOT OVERFILL! This equipment and/or its engine may include evaporative emissions control system components, required to meet EPA and/or CARB regulations, that will only function properly when the fuel tank has been filled to the recommended level. Overfilling may cause permanent damage to evaporative emissions control system components. Filling to the recommended level ensures a vapor gap required to allow for fuel expansion. Pay close attention while filling the fuel tank to ensure that the recommended fuel level inside the tank is not exceeded. Use a portable gasoline container with an appropriately sized dispensing spout when filling the tank. Do not use a funnel or other device that obstructs the view of the tank filling process.

4.Replace fuel cap and tighten.

5.ALWAYS clean up spilled fuel.

GB - 15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Wide Area Walk Mower Introduction Table of ContentsUnauthorized Replacement Parts Dealer Delivery Product RegistrationDisclaimer Practices and Laws SafetySafety Alerts NotationsDismemberment Hazard Safety Decals LocationsDischarge Hazard Emission Control System Safety RulesPage Page Assembly Carton ContentsAssembly Negative Battery Cable Figure Controls and Features Parking Brake Lever Right Hand Lever Controls and FeaturesCutting Height Adjustment OperationPage Filling the Fuel Tank Forward Drive Control Lower Right Hand ControlReverse Drive Control Side Right Hand Control Gasoline Emergency StoppingStarting and Shut OFF Maintenance Schedule MaintenanceSharpen the Mower Blades Change Engine OIL Check AIR CleanerCheck Drive Belts Check FastenersForward/Reverse Drive Controls Service and AdjustmentsWheel Drive Belts Belt ReplacementRemove Figure Install FigureReplacing Mower Blade PTO Belt Deck BeltServicing the Battery U1 Battery Removal and Installation Figure RemoveInstall Install U1-Size Battery Figure Cleaning Battery and Battery Cables or Figure Charging the BatteryJump-Starting Storage TroubleshootingAccessories Service PartsSpecifications Consumer Mowing Equipment Limited Warranty Limitation of Remedy and Damages

911413 specifications

The Ariens 911413 is a powerful and robust snow blower designed to tackle some of the toughest winter conditions. Renowned for its performance and durability, this machine is a favorite among homeowners who face heavy snowfall. One of its main features is the strong 420cc Ariens AX420 engine, which provides ample power for clearing snow with ease. This engine is designed for reliability and efficiency, ensuring that the machine can get the job done without the need for frequent maintenance.

The Ariens 911413 boasts a 24-inch clearing width, allowing it to handle large areas quickly. It can throw snow up to 50 feet, making it an ideal choice for those with long driveways or large outdoor spaces. The snow blower is equipped with a heavy-duty steel auger system that efficiently breaks up and collects snow, ensuring that no snow is left behind. This construction guarantees superior performance even in the most challenging winter conditions.

In terms of technology, the Ariens 911413 features a 6-speed forward and 2-speed reverse transmission, providing users with greater control and flexibility when navigating through deep snow. The self-propelled system allows for effortless movement, reducing user fatigue during operation. Additionally, the machine includes an adjustable discharge chute that can be rotated 200 degrees, enabling users to direct the snow precisely where they want it to go.

Another notable characteristic of the Ariens 911413 is its ergonomic design. The machine comes with heated hand grips, which add comfort during use in frigid temperatures. The quick-release chute clean-out tool simplifies maintenance and ensures that the discharge chute remains clear during operation.

Durability is a key feature of the Ariens 911413, with its heavy-gauge steel frame and reinforced auger housing designed to withstand rigorous use over the years. The snow blower is built to last, giving users peace of mind as they invest in a reliable winter tool. When it comes to performance, features, and efficiency, the Ariens 911413 stands out as a top choice for winter snow removal, providing excellent value and performance for those looking to conquer cold weather challenges.
Top Page Image Contents