Alamo 3109 manual Problem Possible Cause Remedy

Page 90

OPERATION

OPERATION

PROBLEM	POSSIBLE CAUSE	REMEDY

Insufficient lift capacity	Load is greater than boom	Check loader specifications.
	lift capacity.
	Improper hydraulic pump	Repair or replace pump.
	operation.
	Internal lift cylinder leakage.	Replace any worn parts and install
		a seal repair kit. See “Cylinder
		Service”.
	Improper hydraulic valve	Repair or replace valve.
	operation.

Excessive wear on bucket	Bucket is riding on cutting	Use boom “FLOAT” position or
cutting edge	edge instead of wear runners.	bucket level indicator to ensure
		bucket rides

Bucket cutting edge not	Rear axle on tractor not level	With tractor on level surface,
flat on theground.	from side to side	compare rear axle height from left to
		right, measuring from axle center to
		ground. Adjust air pressure in rear
		tires until axle height measures the
		same for both sides.

3109 01/11

Operation Section 4-44

© 2011 Alamo Group Inc.

Image 90

Contents 3109 To the Owner/Operator/Dealer Table of Contents Maintenance Section Safety Section Safety General Safety Instructions and Practices3109 01/11 Safety Section Operator Safety Instructions and Practices Equipment Operation Safety Instructions and Practices SG-36 Safety Safety 3109 01/11 Safety Section SL-33 SPU-2 Safety Transporting Safety Instructions and Practices Maintenance and Service Safety Instructions and Practices Safety Storage and Parking Safety Instructions and Practices Concluding Safety Instructions and PracticesDecal Location QTY Level Description Model Name Loader Positions 3109 01/11 Safety Section Loader Safety Safety Safety Federal Laws and Regulations Introduction Section Introduction Introduction Introduction Before Operating this Machine Page Assembly and Connecting the Loader Section Assembly Assembly InstructionsAssembly Proper Ballasting and Wheel Spacing Dismounting Loader and Mounting Loader to Tractor Dismounting Loader Mounting LoaderInstalling Bucket Level Indicator Asm-L-0169Attaching Pin on Bucket Assembling Quick Attach Device Installing Quick Attach Device When Connecting an Attachment to the Loader Quick Hitch Assembly Operation Section Operation Standard Equipment and Specifications Operator Requirements Operation Personal Protective Equipment PPE Tractor Requirements Rops and Seat BeltTractor Lighting and SMV Emblem Getting On and Off the Tractor Tractor BallastBoarding the Tractor Dismounting the TractorStarting the Tractor Pre-Operation Inspection and Service Tractor Pre-Operation Inspection/Service Loader Pre-Operation Inspection and ServiceMount Assembly OPS-L-0007B Do not Operate an Unsafe Tractor or Front END Loader Front END Loader PRE-OPERATION Inspection Driving the Tractor and Loader Driving the Tractor and Loader Operating the Tractor and Loader Operation Operation SL-33 Operation Operating the Loader Filling the BucketOperation Lifting the Load Carrying the LoadDumping the Bucket Lowering the Bucket Operating with Float Control Loading from a Bank Operation Peeling and Scraping Loading LOW Trucks or Spreaders from a Pile Backfilling Operation Handling Large Heavy Objects Operating Bale Spear Loader Storage Transporting the Tractor and ImplementShutting Down the Implement Operation Transporting on Public Roadways Operation Hauling the Tractor and Implement Troubleshooting Guide Trouble Possible Cause Possible RemedyProblem Possible Cause Remedy Maintenance Section Maintenance 3109 01/11 Maintenance Section Lubrication Schedule Daily Maintenance Cylinder Service Lift and Bucket Cylinder DisassemblyLift and Bucket Cylinder Reassembly StorageMaintenance Proper Torque for Fasteners Maintenance Maintenance Rhino To the OWNER/OPERATOR/DEALER SOM-01/11 F-4293C Printed U.S.A