Exmark E-Series manual Safety

Page 10

Safety

WARNING

Hydraulic fluid escaping under pressure can penetrate skin and cause injury. Fluid accidentally injected into the skin must be surgically removed within a few hours by a doctor familiar with this form of injury or gangrene may result.

If equipped, make sure all hydraulic fluid hoses and lines are in good condition and all hydraulic connections and fittings are tight before applying pressure to hydraulic system.

Keep body and hands away from pinhole leaks or nozzles that eject high pressure hydraulic fluid.

Use cardboard or paper, not your hands, to find hydraulic leaks.

Safely relieve all pressure in the hydraulic system by placing the motion control levers in neutral and shutting off the engine before performing any work on the hydraulic system.

10

Image 10
Contents Pioneer E-SERIES California Introduction Contents Safe Operating Practices SafetySafety Alert Symbol TrainingSafety Operation Slope OperationUsing the Rollover Protection System Rops Maintenance and StorageSafety Safety Safety and Instructional Decals 109-6014 116-1119 107-2102 116-1121 116-3303 116-4465 116-4430 Model Numbers SpecificationsSystems Tires & Wheels DimensionsHydrostatic Ground Drive System Cutting DeckTorque Requirements Motion Control Levers Product Overview OperationControls Choke ControlBrake Lever Ignition Switch Fuel Shut-Off ValveThrottle Control Hour MeterPTO Engagement Switch Drive Wheel Release ValvesDeck Lift Pedal Pre-StartOperating Instructions Transport LockStarting the Engine Open the Fuel Shut-Off ValveEngaging the PTO Stopping the Engine Disengaging the PTODriving the Machine Adjusting the Cutting Height Adjusting the Anti-Scalp RollersTransporting a Unit TransportingLoading a Unit Operation Maintenance Recommended Maintenance SchedulesRecommended Jump Starting Procedure Check Battery ChargeCheck Engine Oil Level Do Not jump start a weak battery if these conditions exist Check Mower BladesCheck Safety Interlock System Service DealerCheck Seat Belt Service Air CleanerCheck Rollover Protections Systems Roll Bar Knobs Check for Loose HardwareLubricate Grease Fittings Check Tire PressuresCheck Condition Of Belts Check Spark PlugsService Interval After the first 100 hours Change Hydraulic System Filter and FluidCopper-Based Anti-seize Check Spark Arrester if equippedThread Locking Adhesives Dielectric GreaseAdjusting the Blade Slope Deck LevelingPump Drive Belt Tension Adjusting the Parking BrakeDeck Belt Tension Motion Control Handle Adjustment Full Forward Tracking AdjustmentMotion Control Linkage Adjustment Adjusting the Seat Ride Suspension Electric Clutch AdjustmentClean Hydro Fan Cooling Fins Clean Engine and Exhaust System AreaRemove Engine Shrouds and Clean Cooling Fins Clean Debris From MachineBattery Disposal Troubleshooting Problem Possible Cause Corrective ActionSee Drive Wheel Release Valves section Schematics Electrical DiagramElectrical Logic Schematic Pioneer E-Series Turf Equipment Page Page Service Record Date Description of Work Done Service Done ByPage This page may be copied for personal use See EXMARK’S Complete Line of Accessories and Options