Exmark FMD524 manual Position Discharge Chute, Service Hydraulic OIL, Support PIN Location

Page 19

FIGURE 1

SUPPORT PIN LOCATION

3.5.5Mower Deck Stationary Idler Installation:

Locate the two holes along the back center section of the deck and install the stationary idler and related parts (from bolt bag) in the right hand hole. See Figure 2. Be sure the coned end of the disc spring washer is against the head of the bolt. Tighten hardware.

3/8-16 x 4 1/2

HEX CAPSCREW

FIGURE 2

STATIONARY IDLER INSTALLATION

3.5.6Install the deck drive belt around the clutch. Refer to belt routing decal. Be sure belt is in the clutch drive sheave groove. Place the other end of the belt into the V-groove of the stationary idler, move the spring loaded idler outward and route the belt around the inside of the spring loaded idler. Position the belt into the V- groove of the mower deck drive sheave. Carefully release the spring loaded idler. Install the center belt shield.

3.5.7Adjust cutting height of deck and anti-scalp rollers. See Adjustment Section 5.2.1.

3.6POSITION DISCHARGE CHUTE:

Loosen two (2) 5/16” nyloc nuts attaching discharge chute. Lower the discharge chute into position. Retighten nyloc nuts until chute is snug but can pivot freely.

3.7SERVICE ENGINE: See Engine Operator's Manual.

3.8SERVICE HYDRAULIC OIL

The machine is shipped with hydraulic oil in the reservoir. Run the machine for approximately 15 minutes to allow any extra air to purge out of the hydraulic system. Check hydraulic reservoir and if necessary fill the reservoir to the appropriate level with Mobil 1 15W-50 synthetic motor oil. Replace hydraulic reservoir cap and tighten until snug. Do not overtighten.

- 14 -

Page 18 Page 20
Image 19
Page 18 Page 20
Contents For Turf Tracer Serial Nos ,000 & Higher FMD524 & FMD604 Potential Hazard Exmark Parts PLUS→ Program Operators Manual Table of Contents Training SafetySafety Alert Symbol Your Safety is InvolvedCarbon monoxide can kill you Potential Hazard Operation Potential Hazard Maintenance and Storage Riding Attachments Safety SignsPage Location Front RH Side of Mower Deck Specifications Torque Requirements DimensionsTires Mower DeckService Battery Assembly InstructionsUncrate Unit Drive Wheels Mower Deck InstallationSupport PIN Location Service Hydraulic OILStationary Idler Installation Position Discharge ChuteFamiliarize Yourself with the Controls Perform Necessary AdjustmentsOperation Instructions Grease UnitDrive LEVER, Neutral Lock Latch Operation Operating Instructions PRE-STARTPotential Hazard Rotating blades under the mower deck are dangerous Transporting Maintenance & AdjustmentsService Interval Daily or more often in dry conditions Periodic MaintenanceFor Serial Nos ,000 539,999 Blade Bolt InstallationBlade Bolt Installation Page Service Interval After First 250 hrs, then yearly thereafter Charge Pump Location Locations Pumps Places Interval Lubrication ChartCaster Wheel Assembly Service Interval Once YearlyPage Cutting Height Adjustment AdjustmentsANTI-SCALP Roller Installation Cutting Height Adjustment Hydro Drive Linkage Adjustment Neutral Safety Switch AdjustmentHydro Control LINKAGE/SWIVEL Adjustment Drive Lever and Latch in Neutral Position Hydro Pump Spring Tension SettingMotor OIL Disposal Trouble ShootingBattery Disposal Waste DisposalMower Cuts Unevenly Engine TroubleshootingEngine will not Start Problem Engine Troubleshooting TableHydraulic Schematic Wiring Diagram Year Limited Warranty Service Record Fold Along Appropriate Line See EXMARK’S Complete Line of Accessories
Top Page Image Contents