f)If either drive wheel still does not rotate, stop and repeat steps (d) and (e) above for the respective pump. If wheels rotate slowly, the system may prime after additional running. Check oil level as stated in Section 5.1.10.
g)Allow unit to run several minutes after the charge pumps are “primed” with drive system in the full speed position. Check oil level as stated in Section 5.1.10.
h)Check hydro drive linkage adjustment as stated in Section 5.2.5.
5.1.13Check tire pressures. Service Interval: 40 hrs.
a)Stop engine, wait for all moving parts to stop, and remove key. Check air pressure in tires; recommended tire pressure is: rear,
b)Inflate tires to pressures stated above. Measure circumference of each drive tire. Adjust tire pressures within the above range to try to make tire circumferences match as closely as possible.
Note: Front caster tires have permanent tire sealant installed.
5.1.14Inspect Belt wear. Service Interval: 40 hrs.
a)Stop engine, wait for all moving parts to stop, and remove key.
b)Remove the three mower deck belt shields to check mower primary and secondary belt condition.
c)Look under engine deck to check the pump drive belt condition.
d)Check all idler arms to be sure they pivot freely.
5.1.15Lubrication
a)Stop engine, wait for all moving parts to stop, and remove key.
b)Lubricate fittings with one to two pumps of NGLI grade #2
Refer to the following chart for fitting locations and lubrication schedule.
LUBRICATION CHART
| FITTING | INITIAL | No. of | SERVICE |
| LOCATIONS | PUMPS | PLACES | INTERVAL |
1. | Caster Wheel Bearings | *0 | 2 | *Yearly |
2. | Caster Pivots | *0 | 2 | *Yearly |
3. | Idler Pivots (Mower Deck) | 1 | 2 | Yearly |
4. | Idler Pivot (Pump Drive) | 2 | 1 | Yearly |
5. | Hydro Control Arm Support Bushings | 2 | 2 | 40 hours |
∗See 5.1.15 Section c) for special lubrication instructions on the front caster pivots and Section 5.1.16 for special lubrication instructions on the front caster wheel hubs.
No. 4 (Idler Pivot (Pump Drive))
Located Under Engine Deck
- 27 -