Exmark FMD524 manual Waste Disposal, Trouble Shooting, Motor OIL Disposal, Battery Disposal

Page 40

FIGURE 16

THROTTLE TENSION

5.2.8Electric Clutch Adjustment No adjustment necessary.

5.2.9Park Brake Adjustment:

a)Shut off engine and wait for all moving parts to stop.

b)Disengage the park brake.

c)Remove the hairpin in the park brake linkage. Turn the linkage in the yoke until there is 3/16” (.48 cm) to 1/4” (.64 cm) clearance between the park brake tire bars and the tires with the park brake disengaged. Re-install the hairpin.

6.WASTE DISPOSAL

6.1MOTOR OIL DISPOSAL

Engine oil and hydraulic oil are both pollutants to the environment. Dispose of used oil at a certified recycling center or according to your state and local regulations.

6.2 BATTERY DISPOSAL

DANGER

POTENTIAL HAZARD

Battery electrolyte contains sulfuric acid, which is poisonous and can cause severe burns

WHAT CAN HAPPEN

Swallowing electrolyte can be fatal or if it touches skin can cause severe burns.

HOW TO AVOID THE HAZARD

Wear safety glasses to shield eyes, and rubber gloves to protect skin and clothing when handling electrolyte.

Do not swallow electrolyte.

Federal law states that batteries should not be placed in the garbage. Management and disposal practices must be within relevant federal, state, or local laws.

If a battery is being replaced or if the unit containing the battery is no longer operating and is being scrapped, take the battery to a local certified recycling center. If no local recycling is available return the battery to any certified battery reseller.

7.TROUBLE SHOOTING

7.1MOWER TRACKS TO LEFT OR RIGHT.

a)Check the drive tire pressures and tire circumferences. See 5.1.13.

b)Turn knob on the right hydro control linkage in the direction that the mower needs to be adjusted to. Turn the knob in 1/4 turn increments until the mower tracks correctly.

-35 -

Image 40
Contents For Turf Tracer Serial Nos ,000 & Higher FMD524 & FMD604 Potential Hazard Exmark Parts PLUS→ Program Operators Manual Table of Contents Safety Safety Alert SymbolYour Safety is Involved TrainingCarbon monoxide can kill you Potential Hazard Operation Potential Hazard Maintenance and Storage Safety Signs Riding AttachmentsPage Location Front RH Side of Mower Deck Specifications Dimensions TiresMower Deck Torque RequirementsService Battery Assembly InstructionsUncrate Unit Mower Deck Installation Drive WheelsService Hydraulic OIL Stationary Idler InstallationPosition Discharge Chute Support PIN LocationPerform Necessary Adjustments Operation InstructionsGrease Unit Familiarize Yourself with the ControlsDrive LEVER, Neutral Lock Latch Operation PRE-START Operating InstructionsPotential Hazard Rotating blades under the mower deck are dangerous Maintenance & Adjustments TransportingPeriodic Maintenance Service Interval Daily or more often in dry conditionsBlade Bolt Installation For Serial Nos ,000 539,999Blade Bolt Installation Page Service Interval After First 250 hrs, then yearly thereafter Charge Pump Location Lubrication Chart Locations Pumps Places IntervalService Interval Once Yearly Caster Wheel AssemblyPage Adjustments Cutting Height AdjustmentANTI-SCALP Roller Installation Cutting Height Adjustment Neutral Safety Switch Adjustment Hydro Drive Linkage AdjustmentHydro Control LINKAGE/SWIVEL Adjustment Hydro Pump Spring Tension Setting Drive Lever and Latch in Neutral PositionTrouble Shooting Battery DisposalWaste Disposal Motor OIL DisposalMower Cuts Unevenly Engine TroubleshootingEngine will not Start Engine Troubleshooting Table ProblemHydraulic Schematic Wiring Diagram Year Limited Warranty Service Record Fold Along Appropriate Line See EXMARK’S Complete Line of Accessories