Exmark M216KA, M216KASP Installing the Starter Rope, Installing the Fuel Tank and the Fuel Line

Installing the Starter Rope

Pull the starter rope through the rope guide on the handle (Fig. 2).

2

1

m±210

Figure 2

1. Starter rope 2. Rope guide

Note: To make the rope easier to install, squeeze the control bar on the handle.

Installing the Fuel Tank and the Fuel Line

1.Start the two self-tapping screws into the bottom of the fuel tank and then remove the screws (Fig. 3).

4

3

2

			5
		1	530
		Figure 3
1.	Tank base	4.	Fuel tank
2.	Fuel tank bracket	5.	Self-tapping screw (2)
3.	Plastic clips

2.Hook the plastic clips on the front of the fuel tank onto the fuel tank bracket (Fig. 3).

3.Secure the fuel tank to the tank base with the two self-tapping screws (Fig. 3). Do not overtighten the screws.

4.Remove the red cap from the end of the fuel line and from the end of the elbow fitting on the fuel tank (Fig. 4).

2

3

1

m-7283

Figure 4

1. Fuel line 3. Fuel valve

2. Elbow fitting

5.Slide the end of the fuel line onto the elbow fitting (Fig. 4).

6.Secure the fuel line in place with the fuel line clamp (Fig. 4).

Installing the Discharge Tunnel Plug

1.Open the discharge door by pulling forward on the handle and moving it rearward (Fig. 5). Hold the discharge door handle to prevent the spring-loaded door from closing while you insert the plug.

1

2

m-1914

Figure 5

1. Discharge door handle 2. Plug rotated clockwise

7