![](/images/new-backgrounds/1263141/26314137x1.webp)
NOTE
It is recommended the access point be mounted with the RJ45 cable connector oriented upwards or downwards to ensure proper operation.
11Cable the access point using either the Power Injector solution or the power supply. For Power Injector installations:
a Connect a
b Connect a
c Ensure the cable length from the Ethernet source to the Power Injector and access point does not exceed 100 meters (333 ft). The Power Injector has no On/Off power switch. The Power Injector receives power as soon as AC power is applied.
For standard 48 volt power adapter (5014000247R) and line cord installations:
a Connect
b Verify the power adapter is correctly rated according the country of operation. c Connect the power supply line cord to the power adapter.
d Attach the power adapter cable into the power connector on the access point. e Plug the power adapter into an outlet.
For
a Connect an
b Ensure the cable length from the
c Verify power is enabled on the
CAUTION
Do not actually apply power to the AP until the cabling portion of the installation is complete.
12Verify the behavior of the access point LEDs. For more information, see “LED Indicators” on page 26.
Altitude 4700 Series Access Point Installation Guide | 19 |
|
|