Exmark Lazer Z XP manual There is no rollover protection when the roll bar is down

Page 10

WARNING

POTENTIAL HAZARD

There is no rollover protection when the roll bar is down.

WHAT CAN HAPPEN

Wheels dropping over edges, ditches, steep banks, or water can cause rollovers, which may result in serious injury, death or drowning.

HOW TO AVOID THE HAZARD

Keep the roll bar in the raised and locked position and use seat belt.

Lower the roll bar only when absolutely necessary.

Do not wear seat belt when the roll bar is down.

Drive slowly and carefully.

Raise the roll bar as soon as clearance permits.

Be certain that the seat belt can be released quickly if the machine is driven or rolls into ponds of water.

Check carefully for overhead clearances (i.e. branches, doorways, and electrical wires) before driving under any objects and do not contact them.

1.4.6Use EXTREME caution when backing up. LOOK BEHIND YOU!

1.4.7Stop the blades when crossing surfaces other than grass and when transporting the mower to and from the area to be mowed.

1.4.8Never operate the mower with damaged guards, shields, or covers. Always have safety shields, guards, switches, and other devices in place and in proper working condition.

1.4.9DO NOT change the engine governor settings or overspeed the engine. Operating an engine at excessive speed may increase the hazard of personal injury.

1.4.10Disengage PTO before starting engine.

1.4.11Start the engine carefully with feet well away from the blades.

1.4.12Keep hands, feet, and clothing away from rotating parts while the mower is being operated.

1.4.13Stop engine, wait for all moving parts to stop, and remove key:

Before checking, cleaning, or working on the mower.

After striking a foreign object (inspect the mower for damage and make repairs before restarting and operating the mower).

Before clearing blockages.

Whenever you leave the mower.

Stop the engine and wait for all moving parts to stop:

Before refueling.

Before dumping the grass catcher.

1.4.14Before stopping the engine, move the throttle control to the “SLOW” position. Keep on running at idle for a short time, (approximately one minute) then stop the engine.

1.4.15The fuel system is provided with a shut-off valve. Shut off the fuel:

When the machine will not be used for a few days.

During transport to and from the job.

When parked inside a building.

1.4.16This mower was designed for one operator only. Keep all others away from mower during operation.

- 5 -

Image 10
Contents For Serial Nos 510,000 & Higher Potential Hazard Exmark Parts PLUS→ Program Operators Manual Table of Contents Safety Alert Symbol SafetyYour Safety is Involved TrainingCarbon monoxide can kill you Operation Safe Zone for Mowing There is no rollover protection when the roll bar is down Maintenance and Storage Engine coolant is toxic Safety Signs Do not Operate Without GuardLocation LH Side of Cutting Page Specifications Tires and Wheels Hydrostatic Ground Drive SystemCutting Deck Dimensions Torque RequirementsUncrate Mower Install Rollover Protection System Roll BAR Assembly InstructionsLower Roll BAR Installation Upper Roll BAR Installation Install Drive WheelsService Battery Machine is shipped with a filled lead acid batteryTilt seat up to gain access to the battery Position Discharge Chute Install Motion Control LeversService Engine Service Engine Coolant Control ARM ShaftOperation Instructions Service Hydraulic OILControls Motion Control Positions Push the lever forward and down to disengage the brake Page PRE-START MowingTransporting Do not drive a unit on a public street or roadway Periodic Maintenance Maintenance & AdjustmentsService Interval Daily Service Interval Monthly Service Interval Daily or more often in dry conditions Blade Bolt Installation Canister type, 2 stage cleaner Engine coolant is toxic Coolant Plug Location Service Interval 40 hrs Service Interval 40 hrService Interval Refer to chart Service Interval Once Yearly Lubrication ChartCaster Wheel Assembly Service Interval 160 hrs Service Interval When Water in Fuel warning light is onService Interval After First 250 hrs Then yearly thereafter Service Interval 800 hrsService Interval As required Service Interval 500 hrsAdjustments ANTI-SCALP Roller Adjustment Cutting Height PositionSwivel Adjustment Spring Compression AdjustmentSelf-tensioning idlers, adjust as follows Self-tensioning No adjustment necessaryMule Drive Belts Adjustment Brake Adjustment Belt Guide PositioningReverse Indicator Adjustment Throttle TensionMotion control linkage adjustment Motion Control Adjustment Caster AdjustmentMotor OIL Disposal Mercury Switch DisposalWaste Disposal Engine Coolant DisposalMower Pulls Left or Right W/LEVERS Fully Forward Trouble ShootingBattery Disposal Mower Cuts UnevenlyProblem Troubleshooting TableEngine Warning Systems Page Electrical Diagram Hydraulic Diagram Year Limited Warranty Page Page Service Record Page See EXMARK’S Complete Line of Accessories