Exmark Lazer Z XP manual Safety Signs, Do not Operate Without Guard

1.6SAFETY SIGNS

1.6.1Keep all safety signs legible. Remove all grease, dirt, and debris from safety signs and instructional labels.

1.6.2Safety signs must be replaced if they are missing or illegible.

1.6.3When new components are installed, be sure that current safety signs are affixed to the replaced components.

1.6.4New safety signs may be obtained from your authorized Exmark equipment dealer or distributor or from Exmark Mfg. Co. Inc.

1.6.5Safety signs may be affixed by peeling off the backing to expose the adhesive surface. Apply only to a clean, dry surface. Smooth to remove any air bubbles.

1.6.6Familiarize yourself with the following safety signs and instruction labels. They are critical to the safe operation of your Exmark commercial mower.

PART NO. 103-3794 LOCATION: LH Side of Console

PART NO. 103-5455

PART NO. 103-3979

LOCATION: RH Side of Console

PART NO. 1-303508

LOCATION: RH Side on Top

Rear of Mower Deck

PART NO. 103-3679

LOCATION: Right of Throttle

LOCATION: Top Front of RH Fuel Tank

Control on RH Fuel Tank

PART NO. 1-513742

LOCATION: Top of Mower Deck

Belt Shields, Left and

Right Sides

DO NOT OPERATE

WITHOUT GUARD

IN PLACE.1-513748

Type A Anti-Scalp Rollers –

See Figure 12

PART NO. 1-323540

LOCATION: Left Rear Corner

Top of Mower Deck

PART NO. 1-403005	PART NO. 1-513748
	LOCATIONS: Bottom Side
LOCATION: Left and Right Corners
	of Floorpan
of Mower Deck
- 8 -