1.4.17Be aware of the mower discharge direction and do not point it at anyone.
1.4.18Do NOT operate the mower under the influence of alcohol or drugs.
1.4.19Use care when approaching blind corners, shrubs, trees, or other objects that may obscure vision.
1.4.20If jump starting is required: (Electric start units only)
a)connect the positive (+) power cable from the positive post on the booster battery to the positive terminal post on the starter solenoid switch (this post has the positive battery cable attached to it).
b)connect the negative or ground cable
c)disconnect battery cables in the reverse order after starting.
1.5MAINTENANCE AND STORAGE
1.5.1For engine maintenance, follow the engine manufacture’s recommendations precisely as stated in the engine manual.
1.5.2Disconnect the battery from the negative battery post when the unit will be allowed to sit for more than 30 days without use.
1.5.3Allowing batteries to stand for an extended period of time without recharging them will result in reduced performance and service life. To preserve optimum battery performance and life, recharge batteries in storage when the open circuit voltage drops to 12.4 volts.
Note: To prevent damage due to freezing, battery should be fully charged before putting away for winter storage.
1.5.4Keep engine and engine area free from accumulation of grass, leaves, excessive grease, or oil and other debris, which can accumulate in these areas. These materials can become combustible and may result in a fire.
1.5.5Store fuel in a container specifically designed for this purpose in a cool, dry place.
1.5.6Keep the mower and fuel container in locked storage to prevent children from playing or tampering with them.
1.5.7Gasoline powered equipment or fuel containers should not be stored in a basement or any enclosed area, where open pilot lights or heat appliances are present.
1.5.8Maximum mowing results and safety can only be achieved if the mower is properly maintained and operated correctly.
1.5.9Check all bolts frequently to maintain proper tightness.
1.5.10Keep all guards, shields, and all safety devices in place and in safe working condition.
1.5.11Frequently check for worn or deteriorating components that could create a hazard.
1.5.12All replacement parts must be the same as or equivalent to the parts supplied as original equipment.
- 6 -