Exmark TT3615KAC, TT4817KAEC, TT5217KA, TT4817KAC Maintenance & Adjustments, Periodic Maintenance

Page 29

5.MAINTENANCE & ADJUSTMENTS

5.1PERIODIC MAINTENANCE

WARNING

POTENTIAL HAZARD

If you leave the key in the ignition switch, someone could start the engine.

WHAT CAN HAPPEN

Accidental starting of the engine could seriously injure you or other bystanders.

HOW TO AVOID THE HAZARD

Remove the key from the ignition switch and pull the wire(s) off the spark plug(s) before you do any maintenance. Also push the wire(s) aside so it does not accidentally contact the spark plug(s).

WARNING

POTENTIAL HAZARD

The engine can become very hot.

WHAT CAN HAPPEN

Touching a hot engine can cause severe burns.

HOW TO AVOID THE HAZARD

Allow the engine to cool completely before service or making repairs around the engine area.

5.1.1Check engine oil level.

Service Interval: See Engine Owner's Manual

a)Make sure mower is on a level surface. Stop engine and wait for all moving parts to stop.

b)Check with engine cool.

c)Clean area around dipstick. Remove dipstick and wipe oil off. Reinsert the dipstick (DO NOT screw into place). Remove dipstick and check oil level.

d)If the oil level is low, add oil as specified in the Engine Owner’s Manual to bring the oil level up to the “FULL” mark on the dipstick.

DO NOT OVERFILL.

IMPORTANT: DO NOT operate the engine with oil level below the “LOW” (or “ADD”) mark or over the “FULL” mark.

5.1.2Clean engine air cooling system.

Service Interval: See Engine Owner's Manual

a)Stop engine and wait for all moving parts to stop. Remove ignition key or spark plug wire(s).

b)Clean all debris from engine air intake screen and from around engine shrouding.

- 24 -

Image 29
Contents Page Potential Hazard Exmark Parts PLUS Program Operators Manual Specifications Table of Contents SafetyAssembly Instructions Maintenance & AdjustmentsYour Safety is Involved SafetySafety Alert Symbol TrainingCarbon monoxide can kill you Potential Hazard Operation Page Maintenance and Storage Riding Attachments Safety SignsPage Page Page Specifications Tires DimensionsTorque Requirements Assembly InstructionsUpper Handle Mounting Blade Engagement Linkage Speed Control Throttle Cable HOOK-UPPage Service Hydraulic OIL ECS Handles Drive Lever Linkage InstallationDrive LEVER, Neutral Lock Latch Operation Operation InstructionsStandard Pistol Grip Handles Pre-Start Potential Hazard Operating Instructions Potential Hazard Transporting Periodic Maintenance Maintenance & AdjustmentsPotential Hazard Blade Bolt Installation Potential Hazard Service Interval After First 250 hrs, then yearly thereafter Charge Pump Location Spray Lubricant Chart Grease Lubrication ChartPage Adjustments Page Neutral Safety Switch Adjustment Hydro Drive Linkage Adjustment Hydro Control LINK/SWIVEL Adjustment Waste Disposal Hydro Pump Spring Tension SettingMotor OIL Disposal Drive Lever and Latch in Neutral PositionBattery Disposal Trouble ShootingMower Tracks to Left or Right Mower Cuts UnevenlyProblem Engine TroubleshootingEngine Troubleshooting Table Wiring Diagrams Hydraulic Diagram Limited Warranty Exmark Commercial Turf Equipment WarrantyPage Page Service Record Fold Along Appropriate Line ALL Rights Reserved See EXMARK’S Complete Line of Products for Turf Care