Exmark 4500-370 manual Deck Removal

Page 10

Setup

Figure 5

1.Secure PTO guard with clevis pin and hairpin

6.Release the deck locking pins on each side, raise mower deck to the service position and secure deck latch onto hook. See Raising the Deck to the Service Position section in Operation.

7.Install springs onto the spring anchor pins under the left and right consoles and secure with a washer and hairpin (see Figure 6).

Deck Removal

1.Stop engine, wait for all moving parts to stop, and remove key. Engage parking brake.

2.Raise mower deck up and latch with deck locking pins per Raising the Mower Deck to the Service Position section in Operation.

3.Remove hairpins and washers at the top of the deck lift assist spring on each side of the unit (see Figure 6).

4.Remove the spring from the spring anchor. Repeat for other side of unit.

5.Un-latch deck from raised position and slowly lower deck to ground per Lowering the Mower Deck to the Operation Position section in Operation.

Note: Deck will become heavier once springs are removed from the anchors. Lower deck carefully.

6.Remove lynch pins at front of push arms on both sides of the unit (see Figure 4).

7.Remove hairpin and clevis from both sides of the PTO guard (see Figure 5).

8.Raise seat and disconnect drive shaft using quick coupler at jackshaft (see Figure 3).

9.Pull mower deck forward to remove from unit.

Important: Do Not transport Navigator tractor without an approved Exmark front mount attachment.

Figure 6

1.Spring anchor pin under console

2.Secure springs with a washer and hairpin

3.Slide spring onto spring anchor pin

8.Un-latch deck from raised position, slowly lower deck to ground and lock deck locking pins on each side Lowering the Deck to the Operation Position section in Operation.

10

Image 10
Contents CD42CD/CD48CD All Rights Reserved Introduction Contents Safety Alert Symbol SafetySafe Operating Practices Maintenance and Storage Safety and Instructional Decals Model Numbers SpecificationsDimensions SystemsSetup Assemble Deck to NavigatorDeck Removal Product Overview Adjusting the Cutting HeightRaising the Mower Deck into Service Position OperationAdjusting Fill Reduction System FRS Baffles Lowering the Mower Deck to the Operating PositionOperation Maintenance Check Mower BladesCheck Tire Pressures Check for Loose HardwareChange Gearbox Oil Lubricate Grease Fittings Lubricate Caster Wheel HubsThread Locking Adhesives Caster Pivot Bearings Pre-load Adjustment Deck Locking Pin Stop AdjustmentDeck Leveling Clean Debris From Cutting Deck Clean Grass Build-Up Under DeckTroubleshooting Problem Possible Cause Corrective ActionExmark Commercial Turf Equipment Service Record Page See EXMARK’S Complete Line of Accessories and Options