Exmark 4500-370 manual Operation

Page 13

Operation

To adjust the FRS baffles:

1. Stop engine, wait for all moving parts to stop and remove key. Engage parking brake.

2. Remove hair pins and clevis pins from both sides

of the PTO guard (see Figure 5). Fold guard forward.

3. Loosen nyloc nuts on the rear studs of the FRS baffles.

Figure 10

1. PTO guard removed for 2. Loosen nyloc nuts clarity

Figure 11

1.Baffles shown in closed position

2.Baffles shown in open position

3.Bolt

4.Washer

5.Baffles

4.Raise deck as stated in Raising the Mower Deck to the Service Position section.

5.Remove bolt and washer at the front of each of the FRS baffles. Rotate baffles into desired position and reinstall bolt and washer.

6.Lower deck per Lowering the Mower Deck to the Operating Position section.

7.Snug nyloc nuts on the rear studs of the FRS baffles. These nuts may be left slightly loose if frequent baffle adjustment is anticipated.

8.Reinstall PTO guard using clevis pins and hair pins removed in step 2.

13

Image 13
Contents CD42CD/CD48CD All Rights Reserved Introduction Contents Safety Alert Symbol SafetySafe Operating Practices Maintenance and Storage Safety and Instructional Decals Dimensions SpecificationsModel Numbers SystemsAssemble Deck to Navigator SetupDeck Removal Raising the Mower Deck into Service Position Adjusting the Cutting HeightProduct Overview OperationLowering the Mower Deck to the Operating Position Adjusting Fill Reduction System FRS BafflesOperation Check Mower Blades MaintenanceCheck Tire Pressures Check for Loose HardwareChange Gearbox Oil Lubricate Caster Wheel Hubs Lubricate Grease FittingsThread Locking Adhesives Caster Pivot Bearings Pre-load Adjustment Deck Locking Pin Stop AdjustmentDeck Leveling Clean Grass Build-Up Under Deck Clean Debris From Cutting DeckProblem Possible Cause Corrective Action TroubleshootingExmark Commercial Turf Equipment Service Record Page See EXMARK’S Complete Line of Accessories and Options