Exmark 4500-370 manual Clean Debris From Cutting Deck, Clean Grass Build-Up Under Deck

Page 19

Maintenance

Cleaning

Clean Debris From Cutting

Deck

Service Interval: Before each use or daily

1.Stop engine, wait for all moving parts to stop, and remove key. Engage parking brake.

2.Clean off any oil, debris, or grass build-up on the cutting deck, especially under deck belt shields.

Clean Grass Build-Up Under

Deck

Service Interval: Before each use or daily

1.Stop engine, wait for all moving parts to stop, and remove key. Engage parking brake.

2.Raise mower deck and secure in latched position (see Raising the Mower Deck to the Service Position section in Operation).

3.Clean out any grass build-up from underside of deck and in discharge chute.

4.Lower deck to cutting position and lock deck locking pins (see Lowering the Mower Deck to the Operation Position section in Operation.

19

Image 19

Contents CD42CD/CD48CD All Rights Reserved Introduction Contents Safety Alert Symbol SafetySafe Operating Practices Maintenance and Storage Safety and Instructional Decals Systems SpecificationsDimensions Model NumbersAssemble Deck to Navigator SetupDeck Removal Operation Adjusting the Cutting HeightRaising the Mower Deck into Service Position Product OverviewLowering the Mower Deck to the Operating Position Adjusting Fill Reduction System FRS BafflesOperation Check Mower Blades MaintenanceCheck Tire Pressures Check for Loose HardwareChange Gearbox Oil Lubricate Caster Wheel Hubs Lubricate Grease FittingsThread Locking Adhesives Caster Pivot Bearings Pre-load Adjustment Deck Locking Pin Stop AdjustmentDeck Leveling Clean Grass Build-Up Under Deck Clean Debris From Cutting DeckProblem Possible Cause Corrective Action TroubleshootingExmark Commercial Turf Equipment Service Record Page See EXMARK’S Complete Line of Accessories and Options